Seat Alhambra 2019, Owner'S Manual

Page: 262 / 380

Driving
● If the brake pedal is pressed.
●
If the airbag is triggered.
●
If the lever is taken out of the D or S posi-
tion.
● If, in the case of a manual gearbox, 1st gear
is engaged.
●
If the clutch pedal is pressed for a long
time.
WARNING
Use of GRA could cause accidents and se-
vere injuries if it is not possible to drive at a
constant speed maintaining the safety dis-
tance.
●
Do not use GRA in heavy traffic, if the dis-
tance from the vehicle in front is insuffi-
cient, on steep roads, with several bends or
in slippery circumstances or on flooded
roads.
●
Never use the CCS when driving off-road
or on unpaved roads.
●
Adapt your speed and the distance to the
vehicles ahead in line with visibility, weath-
er, the condition of the road and the traffic
situation.
●
To avoid unexpected operation of the
cruise control system, turn it off every time
you finish using it.
●
It is dangerous to use a set speed which is
too high for other conditions.
●
If driving down a steep gradient, the GRA
cannot maintain a constant speed. The
speed can increase. In this case, brake and
change down a gear.
Operating the cruise control
Fig. 245
On the left of the steering column:
third lever for operating the GRA.
Connecting
●
Move the lever towards the steering wheel
to position

.
If no speed has been programmed, the sys-
tem will not control it.
Activating the cruise control
● Push button

›››
Fig. 245
1
.
The current speed is stored and the cruise
control is activated.
Temporarily interrupting
●
Move the lever to

and release it, or
step on the brake.
The cruise control system is switched off tem-
porarily. The speed is stored.
Reinstating the cruise control
●
Move the lever to

and release it.
Cruise control is activated at the stored
speed.
Adjusting the speed
While the GRA is set, the stored speed can be
adjusted:
●
Move the lever to the pressure point

to increase speed in small increments of 1
km/h (1 mph).
●
Move the lever upwards
 +
to in-
crease in increments of 10 km/h (5 mph).
●
Press the button

›››
Fig. 245
1
to reduce
speed in small increments of 1 km/h (1 mph).
●
Move the lever downwards
 –
to re-
duce in increments of 10 km/h (5 mph).
To change the stored speed without interrup-
tion, keep the lever pressed in the direction
 +
or
 –
. The vehicle adapts the
current speed by accelerating or stopping
accelerating. The vehicle does not brake ac-
tively.
260