Seat Alhambra 2019, Owner'S Manual

Page: 145 / 380

Transport and practical equipment
down or repositioning the seats, remove
the attachment elements and supports for
the net from the rail system.
Fastening rings*
Fig. 145
In the luggage compartment: fasten-
ing rings.
There are fastening rings
›››
Fig. 145 on the
front and rear of the boot to secure loose ob-
jects and luggage with fastening belts and
cords.
On some models, the fastening rings are lo-
cated right at the back, in the area of the lock
carrier plate.
There are other fastening rings located to the
left and right hand side of the second row
footrests.
WARNING
If unsuitable or damaged belts or retaining
straps are used, they could break in the
event of braking or an accident. Objects
could then be launched across the passen-
ger compartment and cause serious or fa-
tal injuries.
● Always use belts or straps that are suita-
ble and in good condition.
●
Tighten the belts and straps in a cross
layout over the load placed on the boot
floor and secure them to the fastening rings
safely.
●
Never exceed the maximum tensile load
of the fastening rings when securing ob-
jects.
● Make sure that, particularly for flat ob-
jects, the upper edge of the load is higher
than the fastening rings.
●
Depending on the features, take into ac-
count the instruction panels on the boot on
how to place the load.
●
Never secure a child seat to the fastening
rings.
Note
●
The maximum tensile load that the fas-
tening rings can support is approx. 3.5 kN.
●
Belts, straps and securing systems for the
appropriate load can be obtained from
specialised dealerships. SEAT recom-
mends visiting a SEAT dealership for this.
Rail system with fasteners*
Fig. 146
In the luggage compartment: system
including rails, adjustable attachment ele-
ments
1
and adjustable tightening straps
2
.
The rails and attachment system consists of
four rails, movable attachment elements,
straps to be secured to the rails and a net
with supports to cover baggage
›››
page 144 . The rail and attachment sys-
tem is designed to secure light objects. If the
seats in the third row are to be occupied by
passengers then attachment elements
should never be placed in the section of the
rails close to the seats
›››
.
Installing the attachment elements
●
Fit the attachment element with the ruts
facing upwards
›››
Fig. 146
1
to the upper
part of the guide and press downwards.
●
Move the attachment element to the de-
sired position.
»
143