Navigation
38
Specific destinations may also selected from an itinerary by pushing
Start
route
; intermediate destinations are omitted.
When reaching an intermediate destination, an audio indication is given. The
route calculation to the following destination begins automatically.
When the intermediate destination is reached, it is possible to interrupt the
destination guide by pressing
; it may be resumed from the same
position by pressing the
button.
Dynamic destination guide with TMC (Traffic Message Channel)
Starting the demonstration
To begin the demonstration destination guide
Note
•
If you hear a message indicating that you are driving on an unrecognized
road, you should continue to drive. The unit might have to orientate itself
using the next main road.
•
With the destination guide activated, stages may be added or established
destinations altered (
page 24, “Preparing the destination guide”). If a
destination is added, the equipment will prepare an itinerary automatically
(
page 27, “Route planning”), even if the
Route with stages
function is
deactivated in route options (
Dynamic destination guide with TMC (Traffic Message
Channel)
During the dynamic destination guide, traffic reports emitted
by TMC stations are taken into account for route calculation.
In this way, problematic stretches are avoided.
To activate or deactivate this function, press the button
; this will
access the route options pressing
; the dynamic guide status
is selected using the option
Dynamic Navigation
.
It is also possible to press
on the main navigation menu and activate
or deactivate the dynamic guide in the
Route options
.
Once the dynamic destination guide function has been activated you will be
informed that the route is being recalculated due to traffic problems if any
have been registered.
Dynamic destination guide preconditions
In order to use the dynamic destination guide, a TMC station must always be
available (
TMC
indicator on the lower right hand side of the screen). If the
station received does not offer the TMC service, it is possible to search for a
TMC station after beginning the destination guide. A selection may be made
from the
TMC
stations framework
page 11. Once a TMC station has been
found or selected, the destination guide is started.
While the destination guide is operating, other sound sources may be used
(for example an audio CD), even though the TMC reception will remain active
while the reception is good (Note
page 43, “The destination guide without
the navigation CD”). If you continue listening to the radio, the tuned radio
station should offer the TMC service.
If the signal from the TMC station is lost, the radio and navigation system
searches for another similar type station.
If, however, “
maintain without TMC
” has been selected or no TMC station is
being received, the message “
No TMC station registered.
” is displayed. It is
END GUIDE
BEGIN GUIDE
TRAFFIC
ROUTE OPTIONS
ROUTE
Radionaveg300_angles Seite 38 Donnerstag, 13. Oktober 2005 11:48 11
