Seat 2014 LEON CUP RACER, Owner'S Manual

Page: 78 / 284

Operation
Assist systems
submenu
Assist
systems
menu
Function
Lane As-
sist
*
Switching the Lane Assist system on or off
›››
page 168 .
Tiredness
detection
*
Switching the tiredness detection on or off
(pause recommendation)
›››
page 172
.
Driving data
Presets
The MFD (multifunction display) shows differ-
ent values for the journey and the consump-
tion.
Changing between display modes on the
MFD
●
In vehicles without multifunction steering
wheel: Press the rocker switch

on the
windscreen wiper lever
›››
Fig. 87
.
● Vehicles with a multifunction steering
wheel: turn the thumbwheel
›››
Fig. 88
.
Multifunction display memory
The multifunction display is equipped with
three memories that work automatically: MFD
from departure, MFD from refuelling, MFD to-
tal calculation. On the screen display, you
can read which memory is currently dis-
played.
To change between memories with the igni-
tion on and the memory shown, press the
button

on the windscreen wiper lever
or you can also change between memories
using the button

on the multifunction
steering wheel.
Menu Function
MFD from
depar-
ture
Display and storage of the values for the
journey and the consumption from when the
ignition is switched on to when it is switch-
ed off.
If the journey is continued in less than 2
hours after the ignition is switched off, the
new data is added to the data already stor-
ed in the memory. The memory will auto-
matically be deleted if the journey is inter-
rupted for more than 2 hours.
MFD from
refuelling
Display and storage of the values for the
journey and the consumption. By refuelling,
the memory will be erased automatically.
MFD total
calcula-
tion
The memory records the values for a specif-
ic number of partial trips, up to a total of 19
hours and 59 minutes or 99 hours and 59
minutes, or 1999.9 km or 9999 km, de-
pending on the model of instrument panel.
On reaching either of these limits
a)
, the
memory is automatically erased and starts
to count from 0 again.
a)
It varies according to the type of instrument panel fitted.
Erasing a memory manually
● Select the memory that you wish to erase.
● Hold the

button of the multifunction
steering wheel or the

button of the multi-
function wheel pressed down for about 2 sec-
onds.
Personalising the displays
In the Easy Connect system you can adjust
which of the possible displays of the MFD can
be shown on the instrument panel display
with the button

and the function button
Setup
›››
page 81
.
Data summary
Menu Function
Current fuel
consumption
The current fuel consumption display
operates throughout the journey, in li-
tres/100 km; and with the engine run-
ning and the vehicle stopped, in li-
tres/hour.
Average fuel
consumption
a)
After turning on the ignition, average
fuel consumption in litres/100 km will
be displayed after travelling about 100
metres. Otherwise horizontal lines are
displayed. The value shown is updated
approximately every 5 seconds.
ACT
®
*: Depending on the equipment,
number of active cylinders.
76