Seat 2007 Cordoba, Owner'S Manual, Page: 222 / 258

If and when 220
Note
Make sure that when assembling all seals and rubbers are correctly fitted.
Number plate light
– Release transparent lamp cover by levering the tab with the flat
part of a screwdriver.
– Remove the defective lamp from the lamp holder, holding it in
the centre, press to one side and fit new lamp.
– Fit lamp cover in its space, taking special care when replacing the
rubber seal and press until it clicks into place.
Interior light and front reading light
To remove glass
– Insert a fine screwdriver between the casing and the glass
⇒
fig. 156 .
– Carefully remove the glass, levering it to avoid possible damage.
To replace the lamps
– Pull the lamps outwards.
– To remove the central lamp, hold and press to one side.
Assembly
– Proceed in the reverse order, pressing gently on the outer edge
of the side light.
– First fit the glass with the fastening tabs over the frame of the
switch. Next press the front part until the two long tabs click on
the support.
Additional brake lights*
Given the difficulty involved in the replacement of this light it should be done
by the Technical Service.
Glovebox light*
– Insert screwdriver above, between the light and the glove box.
– Carefully remove the light Next lift the light out sideways.
Fig. 156 Front reading
light