MiniWarden Manual
530-487-5007
33
Troubleshooting
Flow not registering even though the magnet is up
Make sure the flow sensor detector wire is connected to the correct switch input. Pool 1 uses Flow 1
and Pool 2 uses Flow 3. On the readings display, the flow indication for Pool 1 is Flow input 1 and for
Pool 2 is Flow input 3, this can’t be changed. If you moved the Pool 1 flow sensor to Flow input 2 the
display will still show the status of Flow input 1.
Rotate the flow sensor ¼ turn. There is a polarity between the magnet and the flow sensor and rotating
the sensor slightly may help.
Alarm light is on, but the readings are OK
There are many factors that affect the alarm status. From the readings screen press the right arrow to
enter the alarm conditions screen. This will list all of the factors from the alarm settings that are causing
the alarm light to be on.
ORP and pH readings are way off
If the ORP and pH sensors wires are swapped this will cause readings that are way off. The ORP
sensor will read near 0 and the pH sensor will be maxed out. Check the wire connections.
Check the circuit boards and make sure they are all properly seated in their connectors.
Clean the sensors and check the date code.
ORP and pH readings are drifting
The most common cause of sensor drifting is a poor earth ground connection to the MiniWarden. A
good way to test the earth ground connection is to measure with a digital voltmeter one of the ground
terminals on the main board in the lid to a piece of metal in the pump room.
Chemical feeders are not turning on
The first test is to make sure they can turn on. Go to the service menu and select Manual Relay Mode
and turn on the feeder to test. If if doesn’t turn on then there may be a problem with the feeder, the
wiring or even the relay.
Try plugging the feeder into an alternate power source to make sure it can turn on.
The setting for the relay control require a flow switch to be on and an overfeed timer to not be reached.
ORP varies from day to night with the same pH and free chlorine
The presence of cyanuric acid in pool water is a challenge for ORP sensors as they detect the waters
ability to oxidize which cyanuric acid has an impact on and is dependant on the amount of sunlight hitting
the water. The MiniWarden has an advanced feature allowing for an automatic decrease in the ORP value
at night to help compensate for this effect (go to the advanced menu for more information). If there is
cyanuric acid in the water then the following guidelines may help:
Only calibrate the ORP sensor at the brightest time of the day. If you calibrate the sensor at night when
the chlorine is all available that will then lead to an overfeed condition on the next day when the sun is
out and the ORP drops.
Forgot Your Password
If you enabled the security feature and forgot your password all is not lost. Contact SeaSide
Automation with the serial number and proof of ownership and a password reset code will be provided
that will clear all of the
