PANEL METER FOR INW PT12 SENSOR
Seametrics • 253.872.0284
Page 8
inwusa.com
Operation
Your meter comes preconfigured to read your INW PT12 Pressure/Temperature sensor.
Once the meter is powered and the sensor is connected, the meter should immediately
begin displaying pressure readings.
Meter Settings
Though your meter comes preconfigured, there may be times when you want to change
some of the settings. The meter is controlled via four buttons on the front of the meter
face:
Figure 3: Meter control buttons
The most common settings are detailed below. For complete settings, see the Appendix.
Slave ID
The Slave ID is the sensor address assigned to your sensor. You can find this address
on the calibration sheet that came with your sensor.
If you need to reset the address in the meter, do so as follows:
MENU RESET MAX ACK
To change a value on
the meter, use the
to
select the digit you want
to change. Use the
to
cycle through acceptable
values.
