9
• It is not necessary to face the receiver to
operate the remote control. Remote signal is
best transmitted within 9 feet (3 meters) of
the receiver.
S A F E T Y
• In the case that an overload of weight is placed
on the head or foot mechanism, the control
unit will automatically stop all functions.
The control unit will automatically resume
all functions 30 seconds after excess weight
is removed.
• Massage motors will automatically shut off
after running continuously for 15 minutes. All
massage functions will be operational again
after 5 minutes. Automatic Shut Off will occur
after 15 minutes of continuous use.
• The input transformer voltage is AC120V 60HZ,
the output voltage is DC24V 3A. In the case
of a short-circuit, a fuse on the transformer
will blow to protect the electrical equipment
(Fuse: 1A~1.5A). Should this occur, you MUST
seek professional assistance to replace the fuse.
Call Customer Care at: 1-800-499-1965.
N O T E :
The changes or modifications not expressly
approved by the party responsible for compliance
could void the user’s authority to operate
the equipment.
The massage feature is programmed with an
Auto Shut-Off Timer that will automatically
turn off the massage after 15 minutes of
continuous use.
S T O P B U T T O N ( M )
Hold down for 2 seconds to stop massage.
W A V E M A S S A G E A D J U S T M E N T S ( N )
Activates both units to wave mode massage.
R E M O T E F E A T U R E S
• The buttons are backlit, when a button is
pressed, to aid in the visibility of the remote in
low light environments.
N O T E :
You must stop massage before alternating between
massage functions.
N O T E :
You must stop the massage in order to activate
another massage setting such as full body or another
wave massage.
N O T E :
This bed may show minor intermittent performance
because of typical RF interference. This is normal in
the operation of the bed, not a defect.
N O T E :
To comply with the FCC RF exposure compliance
requirements, no change to the antenna or the
device is permitted. Any change to the antenna or
the device could result in the device exceeding the
RF exposure requirements and void user’s authority
to operate the device.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1 This device may not cause harmful interference
2 This device must accept any interference
received, including interference that may cause
undesired operation
