6. OPERATION
6.1.
ADJUSTING THE CLAMP (FIG.1)
6.1.1.
The pivot clamp has 10 locking positions. To adjust the clamp, extract the ‘R’ clip and withdraw the pin. Move the pivot clamp to the
desired position, insert the pin and retain with the ‘R’ clip.
6.1.2.
To obtain the optimum fit for differing sizes of motorcycle wheel, adjust the position of the pivot clamp and then test as necessary.
6.2.
POSITIONING MOTORCYCLE IN THE CLAMP
6.2.1.
With the pivot clamp in the open position, align the motorcycle with the clamp.
6.2.2.
Push the motorcycle firmly into the clamp so that the tyre runs through the tapered part of the pivot clamp.
6.2.3.
As the weight of the wheel passes over the pivot clamp, it will cause the clamp to flip over. The front of the tyre will be supported by
the tyre stop and the rear of the tyre by the pivot clamp.
6.2.4.
Check that the motorcycle is stable within the clamp before leaving it. If the wheel is loose, or too high in the clamp, extract the
motorcycle from the clamp and adjust the positions of the clamp until the optimum fit is achieved.
6.3.
REMOVING MOTORCYCLE FROM THE CHOCK.
6.3.1.
More effort will be required to remove the motorcycle from the clamp. Ensure that the space into which the motorcycle will move is free
from obstructions and people.
6.3.2.
Take a firm stance and hold the motorcycle handlebar grips.
6.3.3.
Pull back the motorcycle with sufficient force to overcome the hold of the pivot clamp and release the motorcycle from the clamp.
7. MAINTENANCE
7.1.
Keep the chock clean and wipe off any oil or grease.
7.2.
Before each use check all parts. If any part of the chock is damaged or defective, remove the chock from service and take the
necessary action to remedy the problem.
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Parts support is available for this product. Please email [email protected] or telephone 01284 757500
WCR02 Issue 1 07/09/20
