PETROL ENGINE COMPRESSION TESTER KIT
Model no:
VSE300D
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SafETy
WaRNING!
ensure all Health and Safety, local authority and general workshop practice regulations are adhered to when using these
tools.
8
DO NOT
use tools if seals or threads are damaged. Any defective seal
MUST
be changed before use to avoid incorrect readings.
9
Maintain the tools in a good, clean condition for best and safest performance.
9
ensure that a vehicle that has been jacked up is adequately supported with axle stands.
9
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey Stockist.
9
Wear suitable clothing to avoid snagging, tie back long hair and
DO NOT
wear jewellery.
9
ensure any disconnected fuel pipes are plugged to avoid spillage.
9
ensure that the correct connector is used for the engine/vehicle being tested.
9
Always release the pressure from the gauge before disconnecting the quick release coupling.
9
Account for all tools, and parts being used and
DO NOT
leave them in or near the engine.
WaRNING!
Select neutral (or ‘park’ if automatic transmission) and keep hands clear of the engine as engine rotation may occur
when using these tools. The ignition
MUST BE
turned off, and only switched on when instructed to do so.
IMPORTaNT:
Always refer to the vehicle manufacturer’s service instructions, or a proprietary manual, to establish the current procedure and
data.
These instructions are provided as a guide only.
9
When not in use, return all parts to the protective case and store this in a safe, dry, childproof location.
WaRNING!
The warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situations that
may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
2. INTRODUCTION
Features 300psi gauge with large rubber bumper. Includes extension for deep seated plugs and flexible extension hose. Suitable for
petrol engines with 10, 12, 14 and 18mm spark plug threads. Supplied in carry-case.
fig.1
VSe300d Issue 2 (HF) 12/10/18
Original Language Version
© Jack Sealey limited
Refer to
instructions
Wear eye
protection
