VS8621 - 1 – 15/01/08
7
If the STATUS LED still keeps flashing at a frequency of 5Hz
(5/s), please contact your local distributor or the manufacturer.
4.2 Changing Brake Pads
1) Press
OFF
button to send the command “Start brake pad change”
to the control module. The
OFF LED
flashes at a frequency of 5
Hz (5/s). When the control unit starts to open the pads, the
frequency changes to 1Hz (1/s).
If the OFF LED keeps flashing at a frequency of 5Hz (5/s),
Verify that the ignition is ON;
Check if the service tool’s OBDII/EOBD connector is
securely connected to vehicle’s DLC;
Turn the ignition off, wait about 10 seconds, and turn the
ignition back on.
Make sure that grip brake is released;
Check if the service tool is compatible with the vehicle, as the
current tool is designed for Audi A6, Audi A8, Passat that are
equipped with EPB system;
Check if the vehicle is equipped with EPB system.
If the OFF LED still keeps flashing at a frequency of 5Hz (5/s),
please contact your local distributor or the manufacturer.
2) When the brake is completely opened, the
OFF LED
illuminates
constantly.
3)
Replace brake pad.
4)
When finished pad change, press
ON
button to send the command
“End brake pad change” to vehicle’s control module. The
ON
LED
flashes at a frequency of 5 Hz (5/s). When the control unit
begins to close the pads, the frequency changes to 1Hz (1/s).
If the ON LED keeps flashing at a frequency of 5Hz (5/s),
Verify that the ignition is ON;
Check if the service tool’s OBDII/EOBD connector is
securely connected to vehicle’s DLC;
