INSTRUCTIONS FOR:
Bush Removal Tool -
HONDA CR-V
Model No:
VS726
1.
SAFETY INSTRUCTIONS
2.
APPLICATIONS / PARTS
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give
you years of trouble free performance.
IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
USE THE TOOL CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
WARNING!
Ensure Health and Safety, local authority and general
workshop practice regulations are adhered to when using tools.
DO NOT
use tools if damaged.
Ensure that a vehicle which has been jacked up is adequately
supported with axle stands and that the wheels are chocked,
refer to the vehicle manufacturer’s service instructions, or a
proprietary manual.
Wear approved eye protection. A full range of personal safety
equipment is available from your Sealey dealer.
Wear suitable clothing to avoid snagging. Do not wear jewellery
and tie back long hair.
DO NOT use air tools to operate the force screw.
Maintain tools in good and clean condition for best and safest
performance.
When not in use, clean and lubricate tool, and store in its
storage case in a safe, dry, childproof location.
IMPORTANT:
The force screw must be kept well lubricated.
IMPORTANT: This manual is provided as a guide only, refer to
the vehicle manufacturer’s service instructions, or a proprietary
manual, to establish the current procedure and data.
WARNING!
Failure to heed safety and warning instructions may
result in damage and/or personal injury and will invalidate the
warranty.
WARNING!
The warnings, cautions and instructions
referred to in this manual cannot cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are factors
which cannot be built into this product, but must be
applied by the operator.
Suitable for the removal and installation of the rear trailing arm bush
without damaging the ABS sensor cable. Features a window for
reference while in operation.
Application:
HONDA:
CR-V - K6 and K8 (09/1996 - 08/2002)
•
ALWAYS KEEP FORCE
SCREW WELL
LUBRICATED.
DO NOT USE AIR TOOLS
Original Language Version
VS726 Issue: 1 - 28/10/10
No.
Part No.
Part name
1
VS726.01
Main Body
2
VS726.02
Bolt (x2)
3
VS726.03
Holding Hook (x2)
4
VS726.04
Pusher
5
VS726.05
Allen Bolt
6
VS726.06
Connecting Plate
7
VS726.07
Force Screw
8
VS726.08
Alignment Pin
9
VS726.09
Installation Ring
