5.4.
BEAD BREAKING ON 406mm WHEELS.
With a 406mm wheel resting on the tyre changer foot there is insufficient clearance at ‘X’ in fig.9 to access the tyre bead. To remedy
this situation refer to fig.10. Butt the tyre up against the end of the tyre changer foot, take hold of the handle on the ram mechanism and
pull it away from the main support so it is at an angle as shown at fig.10-‘A’, with the spade close to the bead.
NOTE:
Before operating breaker place one foot on the wheel, opposite the spade, to prevent wheel ‘kick-up’.
Position the bead breaker ram so that the spade is under the rim flange. Open the air valve slightly to lower the spade -
DO NOT
use full
pressure. Check that the spade is firmly set on the tyre bead, close to the rim and then increase the pressure until the bead breaks free.
To proceed refer back to section 5.2.
fig.7
fig.8
fig.9
fig.10
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Original Language Version
© Jack Sealey Limited
TC962.V2 ISSUE 1 26/03/18
