Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
TC904 Issue:1 - 16/01/18
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
Wear eye
protection
Wear ear
protection
Wear protective
gloves
INSTRUCTIONS FOR:
BEAD SEATING TOOL 19ltr - PUSH BUTTON
TRIGGER
MODEL NO:
TC904
1. SAFETY
Ensure the bead seating tool is in good condition before use.
Before carrying out maintenance on the unit
ensure that the pressure has been vented.
Use only authorised attachments and parts. Unauthorised items may be dangerous and will invalidate your warranty.
Keep the work area clean and tidy.
Ensure the working area is well lit.
Always wear safety glasses and ear defenders when using the bead seater.
Keep children and unauthorised persons away from the working area.
WARNING: DO NOT discharge unless the nozzle is positioned on the wheel rim.
DO NOT
use the bead seater to perform a task for which it is not designed.
DO NOT
deface, or remove, the certification plate attached to the bead seater.
DANGER! DO NOT
direct compressed air towards people or animals.
WARNING! The bead seater is a pressure vessel and the following safety measures apply:
DO NOT
use the bead seater without the safety valve fitted.
DO NOT
tamper with the safety valve,
DO NOT
modify or alter the bead seater in any way and
DO NOT
strap anything to it.
DO NOT
subject the bead seater to impact, vibration or heat and
DO NOT
allow contact with abrasives or corrosives.
Drain condensation from bead seater daily, inspect inside walls for corrosion every three months and have a detailed inspection carried
out annually. The bead seater shell must not fall below the certified thickness at any point.
WARNING!
The warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and situations
that may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
2. INTRODUCTION
T
he easy and instant way to seat tubeless tyre beads. Dumps air into tyre void forcing bead to seat against rim for inflation. Air release is
controlled by a diaphragm valve and push-button trigger. Features slotted key to prevent accidental operation of the trigger. Fully certified tank
with gauge and safety valve prevents over pressurising. Suitable for use on cars, commercials, agricultural and ATV tyres.
3. SPECIFICATION
Model No:
...................................................................
TC904
Maximum Pressure: ...................................... 150psi(10.4bar)
Tank Capacity: ................................................................19ltr
Weight: ........................................................................ 13.2kg
fig.1
fig.2
