Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
7. MAINTENANCE
WARNING!
Ensure the tile cutter is disconnected from the electrical mains before performing any maintenance.
7.1.
Should the motor, on/o
ff
switch or the power lead require service or maintenance contact your local Sealey stockist.
7.2.
CHANGING THE CUTTING DISC
WARNING!
Ensure the tile cutter is disconnected from the electrical mains before changing the cutting disc.
7.2.1.
Lift up and remove tilted table (
fi
g 1 - 2) from main tile cutter body.
7.2.2.
Slacken retaining screw (
fi
g 2 - 7) on the cover plate (
fi
g 2 - 6) and remove by sliding cover to the left, and tilting it outwards and
lifting upwards and out of the water reservoir (
fi
g 1 - 15).
7.2.3.
Using shaft wrench and nut wrench (not shown) slacken and remove retaining nut (
fi
g 2 - 5) and cutting disc washer (
fi
g 2 - 1).
NOTE:
The mounting flange (fig 2 - 4) remains on the shaft (fig 2 - 3).
7.2.4.
Position new cutting disc (
fi
g 2 - 2) and blade washer onto the shaft.
WARNING!
When
fi
tting the new cutting disc care should be taken to ensure the rotation arrows on the blade match the rotation
direction arrow (
fi
g 1 - 14) on the cutter table.
7.2.5.
Re-attach the cutting disc cover and re-tighten the retaining screw.
7.2.6.
Re-attach the tilted table into position and lower into place.
7.3.
CLEANING THE TILE CUTTER
7.3.1.
Use a soft damp cloth and mild detergent to clean the tile cutter.
DO NOT
use solvents, petroleum, paint thinner or abrasive cleaners to clean the tile cutter.
DO NOT
store the tile cutter when wet.
TC115 Issue 1 19/02/21
Original Language Version
© Jack Sealey Limited
