instructions for
wheel storage trolley 100kg capacity
model no:
str004.V3
thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. safety
warNiNg! Use wheel storage rack on level and solid ground, preferably concrete. ensure the floor over which the wheel
storage rack will be transported is swept clean.
warNiNg! Do Not use on tarmacadam or any other soft surface as the wheel storage rack may sink or topple.
warNiNg! if a loaded wheel storage rack tips or leans stop what yoUr are DoiNg. MoVe QUickly to a safe
DistaNce.
Do Not try to holD or steaDy wheel storage rack.
9
use wheel storage rack in a suitable work area, keep area clean and tidy and free from unrelated materials. ensure there is adequate
lighting.
9
Before use, ensure that the size and weight of the wheels is known.
Do Not
exceed the capacity of the wheel storage rack.
9
maintain correct balance and footing when loading or moving the wheel storage rack. ensure the floor is not slippery and wear non-slip
footwear.
9
observe correct manual handling techniques when loading wheels on to the wheel storage rack. if in any doubt, obtain assistance.
9
Apply castor wheel brakes when wheel storage rack is stationary.
warNiNg!
DO NOT
use wheel storage rack if any parts are damaged or missing
.
8
Do Not
allow untrained persons to use the wheel storage rack.
8
Do Not
get wheel storage rack wet or use in damp or wet locations or areas where there is condensation.
8
Do Not
use the wheel storage rack when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
Do Not
use wheel storage rack for any purpose other than that for which it is designed.
9
Before storing in safe area, ensure all parts are clean, free of grease and oil.
warNiNg: the warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions
and situations that may occur. it must be understood that common sense and caution are factors which cannot be built into
this product, but must be applied by the operator.
2. iNtroDUctioN
completely free standing wheel storage rack for all types of car wheels with rim size up to
225mm. easy to assemble. the rack has 4 locking castors for easy manoeuvring around the
garage. eliminates tyres distortion due to loss of tyre pressure. supplied with rim protecting
supports.
3. specificatioN
i
Model no: ..............................................................str004.V3
overall size (W x d x H): ....................... 460 x 460 x 1160mm
Wheel capacity: ....................................................................4
maximum rim size: ..................................................... 225mm
maximum weight capacity: ..................100kg (25kg per level)
4. asseMbly
warNiNg!
ensure that you read, understand and apply section 1 safety
instructions.
4.1.
fit the 4 extension legs onto the central linking piece, see fig1.1, (if necessary use a
rubber hammer).
4.2.
secure with the set screws provided and fit the end stoppers.
4.3.
fit castors and apply their brakes until assembly is complete.
4.4.
insert the central tube without the end stopper, see fig.1.2, into the central linking piece.
4.5.
Put a pin through the lowest hole fig.1.3 and place a protective support on top, see fig.1.4.
4.6.
Place the first wheel onto the rack and repeat the procedure for the next wheel.
4.7.
insert the central tube with the stopper fig.1.5 and continue as above until all the wheels
are safely stored.
str004.V3| issue 1 28/09/16
Original Language Version
© Jack sealey limited
refer to
instruction
manual
fig.1
