instructions for
jump starter power pack lithium-ion
phosphate 12/24V 1200/600 peak amps
model no:
sl32s
thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. safety
1.1.
electrical safety for use of charGer
warninG!
it is the user’s responsibility to read, understand and comply with the following electrical instructions:
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices.
An rccB (residual current circuit Breaker) should be incorporated in the main distribution board. We also recommend that an rcd
(residual current device) is used with all electrical products, particularly portable equipment which is plugged into an electrical
supply not protected by an rccB.
9
You must also read and understand the following instructions concerning electrical safety.
The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified
electrician, using a Portable Appliance tester (PAt).
9
the Health & safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and
the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
You must ensure that you:
9
inspect the Jump starter, charger plug, cable and connector for wear and damage to ensure items are safe before connecting to the
mains power supply. if worn or damaged
Do not
use.
9
uncoil the cable between charger and the lamp.
8
Do not
pull the charger plug from the mains socket by the lead.
warninG!
Do not
use any other type of charger with this product, other than the supplied mains or car charger. failure to observe
this warning could result in injury and or fire and will invalidate the warranty.
8
Do not
try to take the charger plug apart.
8
Do not
use the charger plug to charge or power any other electrical item.
8
Do not
get the charger wet, or use in wet, damp conditions (for indoor use only).
1.2.
Battery safety
warninG!
To reduce the risk of burns or fire:
8
Do not
attempt to open, disassemble, modify or service the battery pack.
8
Do not
crush, puncture, short external contacts or dispose of in fire or water.
8
Do not
expose to temperatures above 60°c (140°).
9
replace only with the battery pack designated for this product.
9
recycle or dispose of used battery as stipulated by local regulation.
9
if the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. if it gets in your eyes, rinse thoroughly with cool
water and seek immediate medical attention.
9
ensure the internal battery is fully charged before initial use.
8
Do not
move/handle/use the Jump starter when it is being charged.
8
Do not
leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
recharge the battery at least once every six months of non-use.
▲
DanGer! Be aware, leaD-aciD Batteries Generate eXplosiVe Gases DurinG normal Battery operation.
for this reason, it Very important to reaD anD follow these instructions carefully, each time you use
the jumpstarter.
follow these instructions and those published by the battery and vehicle manufacturers, and the maker of any equipment you intend to
use in the vicinity of the battery. remember to review warning marks on all products and on engines.
sl32s | issue 1 27/04/17
Original Language Version
© Jack sealey limited
refer to
instructions
electrical
shock
hazard
Wear eye
protection
Wear protective
gloves
Warning
corrosive
substance
Warning:
explosive
material
Keep away
from sources of
ignition
use in well
ventilated areas
Keep in dry area
protect from rain
