4.7
SHELF ASSEMBLY (Step 7)
4.7.1 Insert shelf stops (S) at the desired height for each shelf
and lay the shelves onto the stops.
4.8
DOORS ASSEMBLY (Step 8)
4.8.1 Mount each door in turn by placing it between the upper
and lower hinge pivot mouldings. Align the upper hole in
the door edge with the hole in the upper pivot moulding
and insert a hinge pin upwards through the door and into
the moulding. Rotate the short arm of the pin around onto
the inner face of the door as shown above and bend over
the metal tab to retain it. Mount the lower hinge pin in the
same way. Repeat the process to mount the other door.
4.8.2 Fit the rubber door stops (Q) as shown in Step 8 to the
corners of each door
4.9
Using a mild solution of detergent and water and wipe
the unit down with a soft cloth.
4.6
BASE OUTER FASCIA ASSEMBLY (Step 6)
4.6.1 Fit the base outer fascia (E) over the cross member (C)
with the hinge pivot holes facing upwards. Tap the base
outer fascia down with a rubber hammer until the indents
in the sides of the fascia clip into the matching holes on
the cross member (C).
4.6.2 Insert a hinge pivot moulding (K) at each end of the
upper face of the base outer fascia (E). Insert the other
two hinge pivot mouldings at each end of the downward
facing edge of the cabinet top.
4.6.3 Insert a locking rod recess moulding (L) into the centrally
placed holes in the same faces used for mounting the
hinge pivot mouldings at both the top and the bottom.