WARNING!
Disconnect sander from air supply before changing accessories, servicing or performing
maintenance.
Replace or repair damaged parts.
Use genuine parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
5.1
If the air supply system does not have an oiler lubricate the sander daily with a few drops of a good
grade air tool oil, such as Sealey ATO/500 or ATO/1000, dripped into the air inlet (fig.3.8) before use.
5.2
Clean the sander after use and change belt when required.
5.3
Loss of power or erratic action may be due to the following:
a)
Excessive drain on the air supply. Moisture or restriction in the air line. Incorrect size or type of hose
connectors. To remedy, check the air supply and follow instructions in Section 3.
b)
Grit or gum deposits in the sander may also reduce performance. If your model has an air filter
(located in the area of the air inlet), remove the filter and clean it. Flush the sander out with gum
solvent oil or an equal mixture of SAE No. 10 oil and kerosene. Allow to dry then lubricate before
use.
If you continue to experience problems, contact your local Sealey service agent.
5.4
For a full service contact your local Sealey service agent.
5.5
When not in use, disconnect from air supply, clean and store in a safe, dry, childproof location.
4. OPERATING INSTRUCTIONS
5. MAINTENANCE
4.1
Unpack the product and check contents
against the parts listed below. If there is
anything damaged or missing contact your
supplier immediately.
Contents: a) SA635 Belt Sander.
b) 3 x Sanding Belt c) 2 x Hex. Key
WARNING! Ensure that you have read and
understood the safety instructions in
Section 1.
4.2
Loosening clamp bolt (fig.3.1. on the top of
sander) allows the angle between the grip and
the belt to be altered to suit the job in hand.
After adjustment retighten the clamp bolt.
4.3
Once connected to the air supply the sander is started by squeezing the trigger (2).
4.4
To remove and replace the sanding belt push the idle pulley (3) towards the drive pulley (4) against
spring pressure. The pulley bracket (5) will retract and lock allowing removal/fitting of the belt. When the
new belt is in position release the pulley bracket by pushing in and holding the idle pulley, then press and
hold the tension bar (6) whilst releasing the pressure on the idle pulley.
4.5
The tracking of the belt can be altered by adjusting cross head screw (7).
3
5
7
On Reverse
1
8
4
6
2
fig.3
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
W e b
Original Language Version
SA635 Issue: 3(SP) - 23/09/13
© Jack Sealey Limited
