WARNING!
Disconnect gun from air supply before performing maintenance.
5.1
Lubricate the air tool daily with a good grade of air tool oil such as Sealey ATO/500 or
ATO/1000. If the compressed air system has no oiler, a few drops of oil can be poured into
the air inlet of the gun each day.
5.2
When not in use, disconnect from air supply, clean and store in a safe, dry, childproof
location.
Note!
Faults in the compressed air system may cause loss of power or erratic action. Reduced
compressor output, excessive drain on the air line, moisture or restrictions in air pipes or the
use of hose connectors of incorrect size may reduce the air supply.
Grit or gum deposits in the tool will reduce power and may be removed by flushing out the
gun with gum solvent oil or an equal mixture of SAE10 oil and kerosene.
Note!
If the SA401.V2 is used with cartridges for a long period, it is possible that the rubber
plunger may become damaged. If it is then used with manual or bulk filling systems, the
plunger may allow grease to seep from the bottom of the grease tube. To prevent this
happening, check the condition of the rubber plunger, and if worn, replace before using a
different fill method.
5. MAINTENANCE
6. TROUbLESHOOTING
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
Original Language Version
SA401.V2 Issue: 1 - 13/02/12
4.4.3 Operate the filler pump to fill the grease tube.
4.4.4 Disconnect the grease gun from the filler pump.
4.4.5 Press the catch plate and release the plunger rod. Push down on the plunger handle.
4.5 Operation
4.5.1 To operate the grease gun simply push the grease outlet onto the the grease nipple and
operate the trigger until the desired amount of grease has been dispensed.
4.5.2 If you encounter air pockets during operation simply exert force on the plunger, press the air
vent valve (fig.3) and operate trigger in short, sharp bursts until grease begins to flow from
the nozzle.
Fault
Possible Cause
Corrective Action
Loss of power or erratic
action.
Grit or gum deposits in grease
gun air motor.
Air pressure too low.
Flush out grease gun air motor
with a suitable oil.
Check compressed air system for
faults.
Grease gun fails to
dispense grease.
Grease tube is empty.
Loss of prime.
Check grease tube and refill.
Repeat priming operation.
Grease gun continues to
lose prime.
Air pockets in grease tube after
bulk filling.
Plunger binding in grease tube.
Empty grease tube, refill and
repeat priming operation.
Check plunger for free movement.
