4. CHARGING INSTRUCTIONS
WARNING! Ensure that you read, understand and apply the safety instructions before
use.
4.1. Cartridge Loading (fig. 2)
4.1.1. Remove the gun head from the container tube.
4.1.2. Fully draw back the plunger handle.
4.1.3. Insert the open end of the cartridge into the container tube and push it all the way in.
Remove the seal or pull tab end from the cartridge.
4.1.4. Reassemble the gun head to the container tube. Press the catch plate and release the
plunger rod. Push down on the plunger handle.
4.2. Suction Filling (fig. 2)
4.2.1. Remove the gun head from the container tube.
4.2.2. Submerge the open end of the container tube into grease bucket by approximately 50mm
(2”) and slowly pull the plunger handle out fully.
4.2.3. Reassemble the gun head to the container tube. Press the catch plate and release the
plunger rod. Push down on the plunger handle.
4.3. Loading with Filler Pump (fig. 2)
4.3.1. Fully draw back the plunger handle.
4.3.2. Insert filler plug into filler pump socket.
4.3.3. Operate the filler pump to fill the container tube.
4.3.4. Disconnect the grease gun from the filler pump.
4.3.5. Press the catch plate and release the plunger rod. Push down on the plunger handle.
fig. 1
fig. 2
3.4. Line pressure should be increased to compensate for unusually long air hoses (over 8 metres).
The minimum hose size should be 1/4” I.D. and fittings must have the same internal bore.
3.5. Keep hose away from heat, oil and sharp edges. Check hose for wear and make certain
that all connections are secure.
Original Language Version
SA40 Issue: 2 - 08/01/10
