4.1
air supply
recommended hook-up procedure is shown in fig 1.
4.1.1 ensure tool air valve (or trigger) is in "off" position before connecting to the air supply.
4.1.2 You will require an air pressure of 90psi, and an air flow according to specification.
4.1.3
warninG!
ensure the air supply is clean and does not exceed 90 psi while operating the tool. too high
an air pressure and unclean air will shorten the product life due to excessive wear, and may be dangerous
causing damage and/or personal injury.
4.1.4 drain the air tank daily. Water in the air line will damage the tool.
4.1.5 clean air inlet filter weekly.
4.1.6 line pressure should be increased to compensate for unusually long air hoses (over 8 metres).
the minimum hose diameter should be 1/4” i.d. and fittings must have the same inside dimensions.
4.1.7 Keep hose away from heat, oil and sharp edges. check hose for wear, and make certain that all connections
are secure.
4.2 couplings
Vibration may cause failure if a quick change coupling is connected directly to the tool.
to overcome this, connect a leader hose to the tool. A quick change coupling may then be used to connect
the leader hose to the air line recoil hose. see figs 1 & 2.
4.3
universal air swivel Joint
this tool includes a universal Air swivel Joint, which allows the user to manipulate the airline in any way
necessary to easily and successfully complete the task in hand.
warninG! ensure that you read, understand and apply the safety instructions.
5.1
ensure that your workpiece is properly secured and, if necessary, marked out.
5.2
Adjust the depth of cut by sliding the saw blade guide to the required position and secure using the
cross head set screw.
5.3
start the saw and bring the moving blade onto the workpiece.
Do not
attempt to start the saw with the
stationary blade in contact with the workpiece.
5.4
if the cut ends within the sheet material allow the blade to come to a stop before removing the saw from
the workpiece.
5.5
if the cut starts within the bounds of the material cut a starter slot by hand.
5.6
do not allow the saw to run free (whilst not being applied to the material) for any length of time as this will
damage the bearings.
5.7
to change the blade:
5.7.1 disconnect the saw from the airline.
5.7.2 loosen the blade set screws.
5.7.3 remove the blade.
5.7.4 slide the new blade into place and tighten the loosened set screws.
fig. 1
fig. 2
5. operatinG instructions
4. preparinG tooL for use
3. specification
free speed: ...................................................... 5000spm
stroke: ...................................................................25mm
Air consumption: ..................................................... 6cfm
operating Pressure: ............................................... 90psi
noise Power: .................................................... 95.3dB.A
noise Pressure: ................................................ 84.3dB.A
Vibration: .............................................................9.0m/s²
Air inlet size: ......................................................1/4"BsP
Weight: ................................................................... 0.9kg
Blow moulded case, Part no. .....................sA346.V2-c
Original Language Version
sA346.V2 issue: 2 - 20/06/12
© Jack sealey limited
