1. safety instructions
2. introDuction
Thank you for purchasing a Sealey Product. Manufactured to a high standard
this product will, if used according to these instructions and properly
maintained, give you years of trouble free performance.
instructions for:
LonG stroKe, Low noise
Low vibration,
reciprocatinG air saw
model no:
sa346.v2
iMportant: pLease reaD tHese instructions carefuLLy. note tHe safe operationaL reQuireMents, warninGs anD
cautions. use tHis proDuct correctLy anD witH care for tHe purpose for wHicH it is intenDeD. faiLure to Do so
May cause DaMaGe anD/or personaL inJury anD wiLL invaLiDate tHe warranty. pLease Keep instructions safe for
future use.
warninG!
Ensure Health & Safety, local authority and general workshop practice regulations are adhered to
when using this equipment.
warninG!
disconnect from air supply before changing the blade, servicing or performing maintenance.
maintain the
saw in good condition (use an authorised service agent).
replace or repair damaged parts.
Use genuine parts only. Unauthorised parts may be dangerous and will
invalidate the warranty.
use in suitable clean and tidy work area, free from unrelated materials. ensure that there is adequate lighting.
warninG!
Always wear approved eye or face and hand protection when operating the saw.
remove ill fitting clothing. remove ties, loose jewellery and contain and/or tie back long hair.
Wear appropriate protective clothing and keep hands and body clear of working parts.
maintain correct balance and footing. ensure the floor is not slippery and wear non-slip shoes.
Keep children and unauthorised persons away from work area.
check moving parts alignment on a regular basis.
ensure workpiece is secure before operating the saw. never hold a workpiece by hand. use a vice or clamps.
warninG!
ensure correct air pressure is maintained and not exceeded. recommended pressure is 90psi.
Keep air hose away from heat, oil and sharp edges. check air hose for wear before each use and ensure
that all connections are secure.
Prolonged exposure to vibration from this saw poses a health risk. it is the employer’s/owner’s responsibility to
correctly assess the hazard and issue guidelines for safe periods of use and offer suitable protective equipment.
Do not
use any power source except an air compressor.
Do not
operate saw near any inflammable substance or on any container that has held an inflammable
substance.
Do not
use saw for a task it is not designed to perform.
Do not
operate saw if any parts are damaged or missing as this may cause failure and/or personal injury.
Do not
carry the saw by the hose, or yank the
hose from the air supply.
Do not
operate saw when you are tired or under the influence of alcohol, drugs or intoxicating medication.
Do not
carry the saw with your finger on the trigger.
Do not
direct air from the air hose at yourself or others.
When not in use disconnect from air supply and store in a safe, dry, childproof location.
low vibration and low noise saw suitable for professional use. Vibration and noise significantly reduced by up to
50% against standard air saws. long stroke and long blade combination is suitable for cutting sections, pillars,
pipes etc. fully enclosed blade chuck and safety trigger. supplied with two blades (18 & 24tpi), hex key and Z
swivel air hose connector. Also accepts standard sA34 air saw blades.
risk of Hand arm vibration injury
reciprocating Air saw - long stroke. model no. sA346.V2 when operated in accordance with these instructions
and tested in accordance with Bs en 28662-1:1993, iso 8662-1:1988 and Bs en iso 28927-8:2009 results in
the following vibration emission declared in accordance with Bs en 12096:1996.
Measured vibration emission valu
e:
6.6m/s²
uncertainty:
2.64m/s²
these values are suitable for comparison with emission levels of other tools that have been subject to the same
test.
this tool may cause hand-arm vibration syndrome if its use is inadequately managed.
recommended Measures to reduce risk of hand-arm vibration syndrome:
this tool should not be used by an individual regularly for more than 140 minutes in any 8 hour period.
this duration of use should be reduced if the individual is exposed to hand
-arm vibration from other sources.
Original Language Version
sA346.V2 issue: 2 - 20/06/12
© Jack sealey limited
