INSTRUCTIONS FOR:
MOTORCYCLE FRONT/REAR COMBINATION
STAND
MODEL No:
RPS6
Lifts and stabilises the front or rear of any dual sided swing armed bike quickly and easily. Supplied with width and angle adjustable rubber
support pads and bobbin supports, front lifting pin type supports and interchangeable handles. All supports mounted on heavy-duty box
section for continuous professional use.
WARNING! Before use, ensure that there is nothing attached to the front forks, the fairing, or the rear end of the motorcycle, that
will foul the stand.
Maintain the
stand in a good clean condition for the best and safest performance.
Locate the stand and motorcycle in a suitable area. Keep area clean and tidy and free from unrelated materials and ensure that
there is adequate lighting. Also ensure that the floor/ground is level and strong enough (preferably concrete) to take the weight
of the stand and the motorcycle.
DO NOT
mount the stand on tarmacadam, as the surface may be unstable.
Maintain correct balance and footing whilst positioning the motorcycle on the stand, do not over reach and wear non-slip footwear.
Ensure that the floor is not slippery.
Keep children and unauthorised persons away from the work area.
DO NOT
use the stand for a purpose it is not designed to perform.
DO NOT
operate the stand if it is damaged.
DO NOT
use the stand when you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT
allow untrained persons to operate the stand.
DO NOT
make any modifications to the stand.
Before removing a motorcycle from the stand, ensure that there are no obstructions or persons around the motorcycle.
Keep hands and fingers away from moving parts and support pins.
If using as a front stand, always use in conjunction with a suitable rear stand to ensure full stability.
DO NOT
operate the stand if parts are missing or damaged.
DO NOT
attempt to transport a load on the stand.
When not in use, store in a safe, dry, childproof location.
Model No: ....................................................................... RPS6
Minimum/Maximum Front Support Width: ............. 170-260mm
Minimum/Maximum Rear Support Width: .............. 130-270mm
Minimum/Maximum Bobbin Support Width: . . . . . . . 230-350mm
Maximum Weight:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100kg
Original Language Version
RPS6 Issue: 2(I) - 10/03/15
4.1.
The stand is flat packed and requires minimal assembly before first use.
4.1.1. Attach the two side frames to the main handle frame using a nut, bolt and two washers for each side. Normally use the narrow handle
for front fitment and the wide handle for rear fitment. Ensure that the nuts and bolts are fitted correclty, and tighten them so that there
is no movement in the stand. Ensure that the stand sits squarely when placed on the ground.
4.1.2. Fit the required supports - the flat rubber supports (fig.1) or bobbin supports (fig.3), for rear fitment, or the fork supports (fig.2) for front
fitment.
fig.1
fig.2
© Jack Sealey Limited
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
1. SAFETY
2. INTRODUCTION
3. SPECIFICATION
4. ASSEMBLY
Refer to
instruction
manual
