8
DO NOT
check ignition system by removing the spark plug or spark plug lead. Use specific tester or contact service agent.
8
DO NOT
operate the washer in an enclosed area as the motor exhaust fumes are a health hazard. Always ensure adequate ventilation.
8
DO NOT
use the washer with flammable, toxic or corrosive liquids.
8
DO NOT
leave the washer unattended whilst operating, and
DO NOT
remove the fuel cap whilst the engine is running.
8
DO NOT
refuel the engine whilst it is running. Stop the engine and allow it to cool for two minutes before attempting to refuel.
8
DO NOT
refuel in a closed or poorly ventilated environment as there is a danger of explosion or fire. Refuel out doors.
8
DO NOT
smoke or place the washer near any naked flames whilst re-fuelling.
8
DO NOT
operate washer if there is a fuel leak. Move the unit and avoid using until the leak has been fixed and the machine is dry.
8
DO NOT
start the engine if there are any flammable materials near the exhaust system or in the path of the exhaust gases.
8
DO NOT
block the engine ventilation grilles.
9
Ensure engine fuel is stored in an approved container.
9
For long term storage ensure the fuel is drained and that the washer is adequately protected against frost.
8
DO NOT
operate the engine with either the silencer or air filter removed.
8
DO NOT
touch the engine during or after use. To avoid burns, allow it to cool before handling.
2. INTRODUCTION
Petrol powered pressure washer with recoil starting. Suitable for commercial and domestic applications with 5m pressure hose, gun, lance and
adjustable nozzle. Low-pressure liquid detergent injection system. Safety latch on trigger. Unit stands on two sucker feet to prevent movement and
two wheels for easier mobility with an integral handle. Supplied with tools and full instructions.
3. SPECIFICATION
Model no: ......................................................... PWM1300.V2
Manifold pressure: ...................................... 110bar (1595psi)
Maximum pressure:...................................... 150bar(2175psi)
Flow rate: .................................................................... 6L/min
Hose length: ...................................................................... 5m
N
ozzle:
.......................................................
adjustable nozzle
Maximum inlet temperature: ........................................... 40°C
Engine type: ............................4 stroke, single cylinder petrol
Engine capacity: ........................................................... 141cc
Engine power: .................................................................. 4hp
Starting: ........................................................................ recoil
Fuel tank: ........................................................................... 1L
Fuel consumption: ....................................................0.8-1L/hr
Noise level: .............................................................103dB(A)
4. ASSEMBLY AND PREPARATION
Unpack contents and check to ensure all parts are in good condition.
fig.1
fig.2
Item No.
Description
1
Starter cord
2
Spark plug
3
Temperature relief valve
4
Spray gun
5
Fuel tank cap
6
Choke control
7
E
ngine On/Off switch
8
A
ir filter
9
Pump outlet
10
Accessory store
11
Pressure hose
12
Oil dipstick
13
Exhaust
14
Pump inlet
15
Fuel tank
16
Detergent connection
Oil capacity ................................................................... 0.55L
Oil spec. ..............................................................SAE10W-30
Max inlet water pressure ............................................0.4MPa
Min inlet water pressure .............................................0.2MPa
Original Language Version
© Jack Sealey Limited
fig.1
PWM1300.V2 Issue 2 (2) 07/12/20
