!
WARNING!
Disconnect from air supply before changing accessories or servicing.
!
WARNING!
Check correct air pressure is maintained and not exceeded. We recommend
90psi.
!
WARNING! DO NOT
use screwdriver if damaged or faulty. Contact your local service agent.
"
DO NOT use the screwdriver for a task it is not designed to perform.
#
DO NOT hold the workpiece by hand. Use clamps or a vice to secure the workpiece.
"
DO NOT use screwdriver unless you have been instructed in its use by a qualified person.
"
DO NOT drop, throw or abuse the screwdriver.
"
DO NOT carry the screwdriver by the air hose, or yank the
hose from the air supply.
"
DO NOT operate screwdriver if you are tired or under the
influence of alcohol,
drugs or intoxicating medication.
"
DO NOT carry screwdriver with your hand on the power
trigger in order to avoid unintentional starting.
"
DO NOT direct air from the air hose at yourself or others.
$
Follow all workshop Health & Safety rules, regulations, and conditions when using screwdriver.
$
Maintain screwdriver in good condition and replace any damaged or worn parts.
Use
genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
$
Keep air hose away from heat, oil and sharp edges. Check air hose for wear before
each use and ensure that all connections are secure.
$
Keep screwdriver bits clean and in good condition for best and safest performance.
$
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
$
Secure unstable work-piece with a clamp, vice or other adequate holding device.
$
Keep children and unauthorised persons away from the working area.
$
Ensure the screwdriver bit is secure in the chuck.
$
Wear approved safety eye and ear protection.
$
Avoid unintentional starting.
$
When not in use disconnect from air supply and store in a safe, dry, childproof location.
!
WARNING!
The warnings, cautions and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be understood that
common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1.
SAFETY INSTRUCTIONS
INSTRUCTIONS FOR:
AIR STRAIGHT
REVERSIBLE SCREWDRIVER
Model: SA57
2.
INTRODUCTION & SPECIFICATION
Chuck size . .6mm Hex Quick-Release
Free speed . . . . . . . . . . . . . . 9800rpm
Air consumption . . . . . . . . . . . . . 4cfm
Operating pressure . . . . . . . . . . .90psi
Air inlet size . . . . . . . . . . . . . 1/4” BSP
Weight . . . . . . . . . . . . . . . . . . . .0.8kg
Sound power . . . . . . . . . . . . . . . .90dB
Fully polished, machined, aluminium body. Features three speed settings with forward/reverse
control and quick release bit mechanism. Ideal for assembly/dismantling and general production
work. Suitable for use with AK2050 Power Tool Bit Set..
SA57 - (2) - 240707
