3. SET-UP
WARNING! ALWAYS use the pressure washer in the upright position as shown in Fig.2.
3.1
Connecting the water supply.
Use a reinforced hose pipe with an internal diameter of 1/2” and connect to the mains water supply as
indicated in Fig.3. Connect a push fit hose connector (Fig.4-1) to the water inlet on the machine (Fig.4-2). The water supply should
have a minimum pressure of 1.5 bar and a maximum pressure of 6 bar, with a minimum flow rate of 7ltr/min.
Note:
Ensure that the inlet filter (Fig.1-4) is fitted into the water inlet before use.
3.2
Connecting the high pressure hose.
Attach the high pressure hose as indicated in Fig.5 ensuring that the connector is tight. Turn on the water supply.
3.3
Assembling the lance and nozzle.
Push the gun onto the lance as shown in Fig.6. There is a spring within the mouth of the gun. Push the lance against the spring and
turn through 90
o
until it clicks into place. Insert the nozzle required into the end of the lance as shown in Fig.6 and screw it down.
When the nozzle is seated give it a final twist so that it clicks into place. Fig.1-6 is the variable nozzle with adjustable spray pattern.
Fig.1-5 is the Rotablast nozzle.
PC3401
Issue No: 1 - 18/07/08
