6.1.3.
High temperature - When the temperature of the internal heat sink reaches 65°c, the solid state temperature sensor will
automatically shut down the unit. once it is allowed to cool, the unit may be restarted.
7. troUBLe ShootinG
Problem
Possible cause
suggested remedy
unit will not operate
1. Poor dc contact
2. Battery voltage below 10V.
3. load draws too much power.
4. inverter in thermal shutdown.
5. Vehicle battery in poor condition.
6. internal fuses blown due to short
circuit.
1. check all dc contacts.
2. recharge or replace battery.
3. reduce load.
4. Allow inverter to cool.
5. check / replace battery.
6. contact local repair agent or sealey
technical help line for guidance.
low output voltage.
check with voltmeter.
use true rms voltmeter
low voltage alarm sounds continuously.
1. Bad connection or wiring.
2. low battery voltage.
1. check and tighten all dc connections.
2. recharge battery without load.
television interference
1. inverter too close to the television.
1. locate the inverter as far as possible
from the tV, antenna and other cables.
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMportant:
no liability is accepted for incorrect use of this product.
warranty:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
www.sealey.co.uk
01284 757500
01284 703534
web
environmental protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
weee regulations
dispose of this product at the end of its working life in compliance with the eu directive on Waste electrical and electronic
equipment (Weee). When the product is no longer required, it must be disposed of in an environmentally protective way.
contact your local solid waste authority for recycling information.
Pi1000.V3 | issue 1 19/04/16
Original Language Version
© Jack sealey limited
parts support is available for this product. to obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.
