NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMPOrtaNt:
no liability is accepted for incorrect use of this product.
warraNty:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
sole uK distributor, sealey Group.
K
empson Way, Suffolk Business Park,
B
ury st. edmunds, suffolk.
i
P32 7AR
www.sealey.co.uk
01284 757500
01284 703534
environmental Protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
weee regulations
dispose of this product at the end of its working life in compliance with the eu directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. contact your local solid waste authority for recycling information.
Parts support is available for this product. to obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.
6. MaiNteNaNce
6.1.
the hoist should be thoroughly checked over at regular intervals to ensure that it is undamaged and is functioning correctly.
6.2.
isolate from the power supply and inspect the following for any signs of damage, wear or looseness, as appropriate:
a) Lifting cable
d) Mounting brackets/bolts
b) Electrical cables/connections
e) Support structure
c) control switch
rectify any faults that are found, before using the hoist again.
6.3.
Reconnect to power supply and check for correct operation of the control switch and the maximum lift cut-out switch - the hoist should
stop when the counterweight (fig.2.4) lifts the cut-out arm (fig.2.5).
P
H250.V4, PH400.V3 | Issue 2 08/11/16
Original Language Version
© Jack sealey limited
