5.1.
Ensure the machine is unplugged from the
power supply. Make sure the tank is clean and
free from dust and dirt.
5.2.
Remove the dust bag and fit a foam filter over
the filter basket, replace the top section onto
the container.
5.3.
To the same flexible hose as used in dry
cleaning fit the desired nozzle.
5.4.
Ensure the switch is Off (position 0) before
plugging into the power supply.
5.5.
Press the switch to On (position I).
5.6.
After use, empty the tank and dry.
To vacuum large quantities of liquid, from a sink or tank etc., do not immerse the nozzle completely in the liquid, leave a gap at the top of the
nozzle opening to allow an air inflow. The machine is fitted with a float valve which stops the suction action when the tank has reached its
maximum capacity. The user will notice an increase in motor speed. When this happens, turn off the machine, disconnect from power supply,
remove the head from the container and empty the liquid into a suitable receptacle or drain. To continue vacuuming, refit the head and
proceed. After wet vacuuming, turn the machine off and remove plug from power supply. Empty the container and clean/dry the inside and
outside before storage.
Remember!
After wet vacuuming the foam filter must be removed and a dust bag must be fitted before dry vacuuming again.
5. WET VACUUM CLEANING
p
p
WARNING!
Ensure you read, understand and apply Section 1 Safety Instructions. Reminder:
Remove plug from power supply
before opening unit. DO NOT vacuum solvents, explosives, inflammable and/or hazardous liquids such as petrol, oil, spirits, paint,
thinners, acids etc.
6. BLOWING
6.1.
Push the large end of the flexible hose into
the blow connection in the top os the motor
housing.
6.2.
Ensure the power switch is turned off and
plug in the power supply.
6.3.
Switch on the power (position I).
6.4..
The unit will now blow through the vacuum
hose and can be used to clear obstructions
within the pipe.
p
p
WARNING!
If after a few seconds the hose
is still blocked turn off the unit and clear the
hose manually.
7. MAINTENANCE
7.1.
Ensure the machine is unplugged from
the power supply.
7.2.
Disconnect the hose from the container.
7.3.
Undo the clasps and remove the motor
head from the container.
7.4.
Clear out any dirt or debris from the
container and hose.
7.5.
Clean the foam filter by washing it in a
mild soapy solution.
7.6.
Check the hoses and attachments, and
check the power cable to make sure it has
not received any damage.
PC200 - 1 - 180204
Sole UK Distributor,
Sealey Group,
Bury St. Edmunds, Suffolk.
01284 757500
www.sealey.co.uk
01284 703534
Web
