WHEEL CLAMP WITH LOCK & KEY
MODEL NO:
PB397.V3
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Due to the variety in design of vehicles, it is the user’s full responsibility to ensure no damage occurs whilst using this
clamp. Correct attachment of clamp to a vehicle is therefore critical and is beyond control of the supplier.
WARNING!
The user must secure the clamp properly.
8
DO NOT
use the wheel clamp if any parts are missing or damaged as this may cause failure and/or personal injury.
WARNING!
Avoid any protrusions beyond the side of the car as these may present a risk of injury to passers-by.
8
DO NOT
use the clamp for any purpose other than for which it is designed.
9
Ensure that the clamp is removed before using the vehicle or trailer.
9
Ensure all nuts bolts and the locking bar are secure and tight before
leaving the vehicle or trailer unattended.
2. INTRODUCTION
Manufactured from quality steel with zinc plating for corrosion resistance. Simple and
quick ratchet action makes protection easy. Fully lockable and supplied with two keys.
Ideal for forecourt use. Finished in yellow for high visibility.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . .PB397.V3
Maximum Clamp Diameter: . . . . . . . . . . . . . Ø640mm
Maximum Tyre Width:. . . . . . . . . . . . . . . . . . . .225mm
Minimum Clamp Diameter: . . . . . . . . . . . . . Ø450mm
4. ASSEMBLY
4.1.
Insert clamp section ‘A’ (fig.1) into the main plate and secure with supplied nuts and bolts.
4.2.
Insert clamp section ‘B’ (fig.2) into the main plate and secure with supplied nuts and bolts.
4.3.
Turn the key in the lock ‘C’ fully anti-clockwise, to enable the insertion of the locking bar ‘D’ (fig.3).
P
B397.V3 | Issue 1 01/08/2019
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear protective
gloves
fig.1
fig.2
fig.3
