4. APPLICATIONS AND SAFE WORKING LOADS
NOTE:
Only fully qualified personnel should attempt to carry out maintenance, or
repair, on the pulley block.
5.1. Keep the pulley block clean and regularly lubricate the hook shank.
5.2. Carry out a visual inspection every time the pulley block is
used and listen for any unusual sounds during operation.
WARNING! The pulley block should be disassembled, cleaned,
inspected, reassembled and tested by an Authorised Service Agent
annually, or more frequently if used outside, exposed to the weather.
5.3. Depending upon the frequency of use and local conditions, the load rope
will eventually show signs of wear. When it does, it should be replaced
immediately.
5.4. Overloading, or incorrect hooking, may distort the hook and increase the
hook opening. If this occurs replace the hook immediately.
5.5. Inspect the hook for flaws, cracks, distortion, wear and freedom
of rotation.
5.6. Regularly inspect the pulley wheel for wear.
5. MAINTENANCE & INSPECTION
Pulley
Rope SWL(A)
Block SWL(B)
PB1000
500 kg
1000 kg
PB2000
1000 kg
2000 kg
IMPORTANT: WHEN USED AS A SIMPLE LIFTING PULLEY, SEE (A) BELOW,
THE MAXIMUM LOAD IS LIMITED TO THE SAFE WORKING LOAD (SWL)
SPECIFIED FOR THE ROPE.
WHEN USED AS PART OF A TWO-PULLEY SYSTEM, SEE (B) BELOW, THE
MAXIMUM LOAD IS LIMITED TO THE SAFE WORKING LOAD (SWL)
SPECIFIED FOR THE BLOCK.
NOTE: This pulley cannot be used as the upper pulley in a two-pulley system.
4.1
Applications, based on PB1000, are shown below.
Fig.3
Fig.4
Original Language Version
PB1000.V2, PB1500.V2 Issue: 3(L) - 15/05//17
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
