3. Specification
model no: ...............................................................mt680.V4
capacity: ...................................................................... 680kg
min. height: ................................................................ 190mm
max. height: ............................................................... 790mm
standard width: .......................................................... 710mm
max. width: ............................................................... 1220mm
length: ..................................................................... 2000mm
4. aSSembly
refer to parts diagram below.
4.1.
lay the sliding plate (8) onto the platform (1).
4.2.
connect the oil hose coupler (29) to the port on the hydraulic pump (20).
4.3.
connect air hose into the end of the air/manual pump (20).
4.4.
Attach the leading plate (9) to the end of the platform (1).
4.5.
insert safety handle (36) through detent on rear end of lift and screw into thread on the bracket on the end of the safety wire (31).
4.6.
tighten lock nut (35).
4.7.
Fit motorcycle wheel clamp (also see fig.1)
4.8.
fit crank handle assembly (40) to platform (1) through pre-drilled holes, use bolt (5) washer (38) and nut (7).
4.8.1.
fit moveable vice jaw (2) to crank handle assembly (40), use bolt (6).
4.8.2.
Fit fixed vice jaw (3) to platform (1), use bolt (5).
4.8.3.
fit stop plate (4) to platform (1), use bolt (5).
4.9.
fit side extensions
4.9.1.
Pass connecting bars (42) through front and rear holes in platform (1). slide on side extensions (41).
4.9.2.
secure at each end of the connecting bars (42) with position pins (44). fit pin through hole on the end of the connecting bar and
secure with lock nut (34).
4.9.3.
fit side extension ramp extensions (43).
fig.1
mt680.V4 | issue 1 - 21/04/16
Original Language Version
© Jack sealey limited
