RECHARGEABLE 360
°
INSPECTION LAMP
14 SMD LED+3W LED LITHIUM-ION
MODEL NO:
LED360.V5 SERIES
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9
Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or
damaged
DO NOT
use.
9
Ensure the lamp is fully charged before initial use.
8
DO NOT
charge in damp conditions.
8
DO NOT
turn the lamp on when it is being charged.
8
DO NOT
shine directly into your, another person’s or an animal’s eyes.
8
DO NOT
allow children to use the lamp.
8
DO NOT
handle or move the lamp whilst it is being charged.
8
DO NOT
use the lamp if you suspect that the battery or the lamp casing is damaged.
8
DO NOT
leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
recharge the battery at least once every six months of non-use.
8
DO NOT
attempt to open, disassemble, modify or service the battery pack.
8
DO NOT
crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT
expose to temperatures above 60°C (140°).
9
Replace only with the battery pack designated for this product.
9
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool
water and seek immediate medical attention.
2. INTRODUCTION
Unique and innovative 360° swivel and tilt function enables the light source to be positioned in any direction. Exclusive patented design owned by
and registered to Sealey. Each lamp houses 14 super bright SMD LEDs providing up to 600 lumens output with 120° spread of light, illuminating
the whole work area. Includes an additional high power 3W LED directional torch. Features two swivel hooks and three rubber covered magnets,
two on the rear and one on the end, which allow hands-free operation. High quality 2.6Ah Lithium-ion battery for longer life, no memory effect and
a much slower discharge than traditional Ni-MH batteries. Features a micro USB charging port and supplied with USB charging lead.
3. SPECIFICATION
Model No .............................................................LED360.V5
Battery ........................................................3.7V 2.6Ah Li-ion
LED Quantity................................................. 14SMD + 1LED
Lumen Output Side(High/Low)Top ............... (600/200)/120lm
Operating Time Side(High/Low)/Top ........................ (3/6)/8hr
Charging Time ................................................................3.5hr
IP Rating .........................................................................IP54
Minimum Length ........................................................ 260mm
Maximum Length ....................................................... 280mm
The battery fitted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time.
We will provide warranty against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear.
If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances
we will not replace the battery regardless of whether it is less than one year old.
Note:
The lithium battery does not suffer from memory effect and once fully charged may be stored for up to six months without
another charge.
4. OPERATION
4.1.
Connect the USB lead to the socket on the rear of the lamp and into a charging socket. Turn on power supply, the charging LED on
the lamp will light RED to show that charging has commenced.
4.2.
When the battery has fully charged the LED will turn GREEN.
4.3.
Direct the lens away from your eyes before switching on.
Original Language Version
© Jack Sealey Limited
Refer to
instructions
LED360.V5 Series | Issue 2 (2,F)20/03/18
