WARNING!
Ensure that you read, and fully understand the safety instructions before use.
4.1
. Charge the batteries before use.
IMPORTANT:
Ensure the floodlight is turned ‘Off’ whilst charging. Failure to do so could damage the charger plug.
4.2. BATTERY CHARGING
WARNING!
Ensure that you read, fully understand, and apply the safety instructions relating to the battery and charger
before use.
4.3. MAINS CHARGER PLUG
4.3.1. Ensure the floodlight is turned ‘Off’ and then plug the charger adaptor into the jack inlet (fig.1.) above the on/off switch.
Ensure that the notch in the plug (fig.2) engages with the finger in the socket to ensure correct polarity and that the plug is
screwed onto the socket by the external collar.
4.3.2. Plug charger the into the electrical supply.
4.3.3. Allow approximately 4 hours for the initial charge and for subsequent charges.
4.3.4. When the batteries are fully charged, the indicator LED on the charger will change from red to green
4.3.5. When full charge has been reached, switch off the mains supply and unplug the charger from the electricity supply and then
from the floodlight. The floodlight is now ready for use.
4.3.6. Store the charger in a safe, dry location.
4.2
. Turn floodlight ‘On’ and ‘Off’ by the switch at the rear of the body. The first press selects low power; a second press selects
high power.
4.2.1. The angle of the lamp may be altered by rotating the support bracket (fig.1).
Notes:
a) Fully charged batteries will last for approximately 8 hours on low power or 2.5 hours on high power.
b)
DO NOT
fully discharge the batteries before recharging.
c)
DO NOT
leave batteries in a discharged state, recharge batteries immediately. If the floodlight is not in use, recharge
the batteries every three months.
NOTE:
The Li-ion battery does not suffer from memory effect and once fully charged the floodlight may be stored for up to 6
months before recharging is required.
Original Language Version
LED057 Issue: 1 - 03/09/15
© Jack Sealey Limited
Model No:
. . . . . . . . . . . . . . . . . . . . . . . . .
LED057
Battery: . . . . . . . . . . . . . . . . . . . 11.1V - 4.4Ah Li-ion
Lumen Output: . . . . . . . . . . . . . . . . . . . .200/1400lm
CRI Rating:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 95
Operating Time: . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8/2.5hr
Charging Time: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4hrs
2. INTRODUCTION
3. SPECIFICATION
4. OPERATION
Rechargeable work light with super bright COB LED light source which gives an even and constant spread of light. Produces up to 1400 lumens
with a CRI (Colour Rendering Index) of 95, which gives an effect of daylight. Two settings allow for 30% or full brightness to suit task. Suitable for
accurate colour matching and identifying bodywork imperfections or an environment needing good lighting. Supplied with 180° adjustable stand
and is IP65 rated.
fig.1
fig.2
