Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give
you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS
INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1.1. GENERAL
WARNING!
Disconnect lamp from power before performing any maintenance.
DO NOT
shine lamp directly into your, other person’s or animal’s eyes.
DO NOT
allow children to use the lamp.
Maintain the lamp in good condition.
DO NOT
use the lamp if the lamp if damaged.
When not in use store the light in a safe, dry, childproof location.
WARNING!
Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using this light.
Wear approved eye protection. A full range of safety equipment is available from your Sealey dealer.
Wear suitable clothing to avoid snagging.
DO NOT
wear jewellery and tie back long hair.
Account for all tools being used and
DO NOT
leave them in or near the engine.
WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood that common sense and caution are factors which must be applied by the operator.
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LED042
SMD Quantity: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
Lumen Output: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .200lm
Dimensions: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .300 x 24 x 6mm
Featuring 12 SMD LEDs mounted in a slimline body allowing use in the tightest of spaces. Resistant to oil, chemicals and water. Suitable for use in
industrial and automotive environments. Supplied with both 12V DC vehicle cigarette lighter socket connector and direct battery connector.
4.1.
CONNECTING TO BATTERY TERMINALS
NOTE: Check the battery is 12V DC. DO NOT use a 6V or 24V battery.
4.1.1 Ensure the battery terminals are clean, if necessary clean away any dirt or corrosion.
4.1.2 Check to make sure no flammable fumes are present.
4.1.3 Clip the red (+) battery clip to the positive terminal and the black (-) clip to the negative terminal on the battery.
4.1.4 Check all connections are secure.
4.1.5. Turn lamp on by sliding switch to 'On' position, see fig.1.
Original Language Version
LED042 Issue: 1 - 14/04/14
InSTRuCTIOnS FOR:
INSPECTION LAMP SLIMLINE 12 SMD 12V
MODEL nO:
LED042
1. SAFETY
2. INTRODUCTION
3. SPECIFICATION
4. OPERATION
5.1 WARNING! Be sure to disconnect the lamp from the power supply before carrying out any maintenance.
5.1.1. Keep lamp clean and check for damage before every use. If damage is observed, remove from use until unit is repaired by a qualified
electrician.
5. MAINTENANCE
© Jack Sealey Limited
