NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
S
ole UK distributor, Sealey Group.
K
empson Way, Suffolk Business Park,
B
ury St. Edmunds, Suffolk.
IP32 7AR
www.sealey.co.uk
01284 757500
01284 703534
Web
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
WEEE Regulations
D
ispose of this product at the end of its working life in compliance with the EU directive on Waste Electrical and Electronic
Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way.
Contact your local solid waste authority for recycling information.
7.11.
W
here a build-up of non-water soluble paint has occurred, the filter cannot be cleaned and will have to be replaced. To prolong filter life,
place the main unit as far away as possible from the spraying area.
8.
tr
TROUbLESHOOTING
Problem
cause
Solution
Poor atomisation, heavy centre
pattern.
F
luid flow is too high for the air flow.
1. Reduce fluid flow using the fluid
control knob.
2. Fluid could be too thick, dilute.
Heavy atomisation, poor centre
pattern.
Fluid is too thin.
1. Increase proportion of fluid to
thinning medium.
Intermittant spray pattern.
A
ir entering the fluid supply.
1. Tighten the connection between the
cup and the gun.
2. Check if paint pot is empty.
Heavy right or left side pattern.
O
ne of the horn holes blocked (A).
1. Place the nozzle in cleaning
solution.
2. Clean hole with compressed air
or with a soft probe.
DO NOT
use a
metal probe which will damage the
hole.
Top heavy or bottom heavy pattern.
P
ossible fluid build up between fluid
nozzle and needle.
1. Clean the fluid nozzle, check also
that they match correctly.
2. Check needle for damage.
H
VLP2000.V2 | Issue 2 - 21/10/15
Original Language Version
© Jack Sealey Limited