2. INTRODUCTION
P
art of the SV20 Series offering a one-battery-fits-all solution, keeping costs down without compromising on performance. High velocity
continuous variable speed drum fan which is mains or cordless power meaning increased versatility in positioning cooling where it is most
required. Lightweight, portable and robust unit fitted with rubber feet for stability. Features a handle plus 360° tilting stand allowing control of
airflow to exactly where it is needed. Carefully balanced and fully guarded aluminium blades provide quiet and safe operation and is suitable
for use in industrial, commercial, agricultural, automotive workshop, showroom and home applications. To run cordless requires compatible
20V battery and mains charger, sold separately. CP20VBP4 (4Ah), CP20VBP6 (6Ah), CP20VMC (Mains Charger).
3. SPECIFICATION
Model No:................................................................HVD16C
Current: ...........................................................................1.2A
Fan diameter: ....................................................................16”
M
aximum Airflow:
..................................................... 1650cfm
Power: .............................................................................24W
Speed Range: ...................................................580-1470rpm
Speeds: ....................................... Continuous Variable Speed
Supply: ................................................................... 20V 220V
4. ASSEMBLY
4.1.
Assemble fan as shown in fig.1. To tighten fan at an angle use thumb wheels (fig.1.1, fig.1.3).
4.2.
Connect battery to unit (fig.2.A). See safety section for guidance. Note supply terminals (fig.2.B). Polarity is marked on the body.
4.3.
When using the mains supply, see safety section for guidance. Insert power supply cable to port on appliance (fig.2.D).
5. OPERATION
WARNING!
Ensure that you read, understand and apply safety instructions in Section 1 before using fan.
5.1.
Check that the speed control is set to OFF and then plug into power supply or fit battery (fig.2) and switch the power on.
5.2.
To adjust the fan speed use the control knob on the Power Adaptor (fig.3)
5.3.
Adjust the direction of the air flow by moving from side to side and tilting the fan up or down as required (fig.1).
5.4.
Turn the speed control switch to OFF and disconnect the fan from mains power or remove battery pack after use (fig.2, fig.3).
6. MAINTENANCE
WARNING! Ensure that the fan is disconnected from the mains power supply before attempting any of the following:
6.1.
Use a soft, damp cloth to clean the fan.
8
DO NOT
immerse the fan in water and never allow water to drip onto the motor housing.
DO NOT
use solvents, petroleum, paint
thinner or other chemicals to clean the fan.
6.2.
To clean the fan blade, undo the cross headed screws around the circumference, remove the grille and clean the blade with a
slightly damp cloth. Replace the grille as required and refit the cross headed screws.
6.3.
Should the motor, switch or the power lead require service or maintenance contact your local Sealey stockist.
Original Language Version
© Jack Sealey Limited
F
ig.3
Maximum Fan Flow Rate (F):
48.5m³/min
Fan Power Input (P):
22.8W
Service Value (SV):
2.1 (m 3 /min)/W
Standby Power Consumption (Psb):
0.3W
Seasonal Electricity Consumption (Q):
7.6kWh/a
Fan Sound Power Level (Lwa):
68dB(A)
Maximum Air Velocity (c):
3.4m/s
HVD16C Issue 1 19/04/22
Fig.2
Fig.1
