INSTRUCTIONS FOR
GRAVITY SPRAY GUN 1.3MM SET-UP
FINISHING COAT
MODEL NO:
HP01
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9
Familiarise yourself with the application and limitations, as well as the potential hazards of the spray gun.
WARNING!
Disconnect the spray gun from the air supply before changing accessories, servicing or performing any maintenance.
9
Maintain the
spray gun in good condition (use an authorised service agent).
9
Replace or repair damaged parts.
Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Locate the spray gun in a suitable work area, keep area clean and tidy and free from unrelated materials, and ensure that there is
adequate ventilation and lighting.
9
Keep the spray gun clean for best and safest performance.
9
Ensure the air system has sufficient output for the spray gun air consumption (see specification).
9
Wear approved respiratory protection, safety eye goggles and skin protection.
9
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and tie back long hair.
9
Keep children and unauthorised persons away from the work area.
9
When gun is not in use ensure the air supply is disconnected.
9
Avoid unintentional operation.
8
DO NOT
paint were there is any source, or possible source, of ignition as paint mist is extremely flammable.
8
DO NOT
point spray gun at yourself or at other persons or animals.
8
DO NOT
carry the spray gun by the air hose, or yank the hose from the air supply.
8
DO NOT
use the spray gun for any purpose other than for which it is designed.
8
DO NOT
allow untrained persons to operate the spray gun.
8
DO NOT
get the spray gun wet or use in damp or wet locations or areas where there is condensation.
8
DO NOT
operate gun if any parts are missing or damaged as this may cause failure and/or personal injury.
8
DO NOT
direct air from the air hose at yourself or others.
2. INTRODUCTION
G
ravity feed spray gun designed for applying clear finishing coats. Air cap engineered to deliver high mist pressure for rapid paint application
and extended working distance. Stainless steel air and laquer flow channels provides long life. Features air and laquer flow controls for fine
adjustment of spray pattern.
3. SPECIFICATIONS
Model no: ..................................................................... HP01
Standard set up: .......................................................... 1.3mm
Air pressure: ............................................................. 29-32psi
Air consumption: ....................................................... 10.1cfm
Pot capacity: ................................................................ 600ml
Refer to
instruction
manual
HP01 Issue No:1 04/11/15
Original Language Version
© Jack Sealey Limited
Wear eye
protection
Wear
respiratory
protection
