Refer to
instructions
Wear eye
protection
PNEUMATIC PAINT CAN CRUSHER
model no:
HCC08
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
HCC08 | Issue 2 (HF) 03/10/18
Original Language Version
© Jack Sealey limited
fig.1
1. SAFETY
WARNING!
Wear protective gloves and approved safety eye protection (standard spectacles are not adequate).
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.
8
DO NOT
allow untrained persons to use the crusher.
8
DO NOT
operate the paint can crusher when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT
operate the crusher if parts are damaged or missing as this may cause failure and/or personal injury.
8
DO NOT
use the crusher for a task it is not designed to perform.
8
DO NOT
crush aerosol cans, cylinders of compressed gas, fuel cans or containers of flammable liquids or solvents.
8
DO NOT
smoke when using crusher.
8
DO NOT
modify the crusher or alter the operation in any way to circumvent the interlocking door mechanism.
9
R
emove lids, place paint cans into the crushing chamber open side down.
9
m
aintain the paint can crusher in good condition. Replace or repair damaged parts.
9
U
se genuine parts only. Unauthorised parts may be dangerous and invalidate the warranty.
9
F
amiliarise yourself with the applications, limitations and potential hazards of the paint can crusher.
9
K
eep work area clean, uncluttered and ensure there is adequate lighting.
9
m
aintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
9
K
eep the crusher clean for best and safest performance.
9
W
hen not in use release pressure from the paint can crusher.
9
W
ear appropriate PPE such as overalls safety glasses and gloves.
9
K
eep untrained/unauthorised personnel away from the crusher.
9
C
lean up any spilled paint immediately so it will not cause a slipping hazard.
9
l
eave the door ajar when not in use.
2. INTRODUCTION
Reduce your waste disposal costs* - crushing paint cans minimises the volume of your hazardous waste. Air operated paint can press
with safety lock-out device which prevents the door being opened during operation. Bench mounting unit with outlet for waste paint collection.
* For disposal by volume customers.
3. SPECIFICATION
Internal Size (H x W x D):.......... .................250 x 280 x 230mm
External Size (H x W x D):......... .................750 x 390 x 250mm
Air Supply:................................................ .................100-130psi
Air Inlet:......................................................... ................ 1/4”BSP
Weight:................................................................ ................41kg
4. INSTALLATION
WARNING!
The unit is very heavy and should
only be moved with assistance.
4.1
LOCATION AND INSTALLATION.
Locate the crusher in a suitable place indoors
on a firm and level surface.
4.2
FITTING PIPES.
The pipes are a simple push fit and should be configured
as in Fig.1 ensuring the pipes are fully inserted.
4.3 REGULATOR.
Use the large nut to attach the regulator to the body
and insert the pipe as in Fig.1.
