sealey Group, Kempson Way, suffolk business Park, bury st edmunds, suffolk. iP32 7ar
01284 757500
01284 703534
www.sealey.co.uk
note
: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important
: no liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
environment Protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
a) excessive drain on the air line. moisture or restriction in the air pipe. incorrect size or type of hose connectors. to remedy check the
air supply and follow instructions in section 3.
b) Grit or gum deposits in the sander may also reduce performance. if your model has an air strainer (located in the area of the air
inlet), remove the strainer and clean it. flush the sander out with gum solvent oil or an equal mixture of sAe no 10 oil and kerosene.
Allow to dry before use.
if problems continue, contact your local sealey service agent.
6.4.
for a full service contact your local sealey service agent.
6.5.
When not in use, disconnect from air supply, clean sander and store in a safe, dry, childproof location.
WarninG! – risk of Hand arm vibration injury.
this tool may cause Hand arm vibration syndrome if its use is not managed adequately.
this tool is subject to the vibration testing section of the machinery directive 2006/42/ec.
this tool is to be operated in accordance with these instructions.
this tool has been tested in accordance with:
EN ISO 28927-3:2009 & BS EN ISO 15744:2008.
declaration and verification of Vibration emission figures are in accordance with en 12096:1997
measured vibration emission value (a): 4.5 m/s²
uncertainty value(k): 2.25 m/s²
Please note that the application of the tool to a sole specialist task may produce a different average vibration emission. We recommend that a
specific evaluation of the vibration emission is conducted prior to commencing with a specialist task.
A health and safety assessment by the user (or employer) will need to be carried out to determine the suitable duration of use for each tool.
nb:
stated Vibration emission values are type-test values and are intended to be typical.
Whilst in use, the actual value will vary considerably from and depend on many factors.
such factors include; the operator, the task and the inserted tool or consumable.
nb:
ensure that the length of leader hoses is sufficient to allow unrestricted use, as this also helps to reduce vibration.
The state of maintenance of the tool itself is also an important factor, a poorly maintained tool will also increase the risk of Hand Arm Vibration
Syndrome.
Health surveillance.
We recommend a programme of health surveillance to detect early symptoms of vibration injury so that management procedures can be modified
accordingly.
Personal protective equipment.
We are not aware of any personal protective equipment (PPe) that provides protection against vibration injury that may result from the uncontrolled
use of this tool. We recommend a sufficient supply of clothing (including gloves) to enable the operator to remain warm and dry and maintain good
blood circulation in fingers etc. Please note that the most effective protection is prevention, please refer to the correct use and maintenance section
in these instructions. Guidance relating to the management of hand arm vibration can be found on the Hsc website www.hse.gov.uk - Hand-Arm
Vibration at Work.
GsA70 | issue:3 (l) 21/09/17
Original Language Version
© Jack sealey limited
