4.3.
Operating
Warning!
ensure you read, understand and apply safety instructions.
4.3.1. connect the die grinder to the air supply.
4.3.2. to start, hold firmly and push the trigger locking lever forward whilst depressing trigger.
4.3.3. the bit must be running at its maximum speed before attempting to grind the work piece.
4.3.4. slowly and smoothly bring the grinding stone toward the work piece (avoid jerky movements).
Avoid subjecting stone to excessive strain or harsh impacts.
Always hold die grinder firmly and ease grinding stone against work piece. maintain a controlled progression.
4.4.
changing grinding Stones
Warning!
disconnect from the air supply before changing grinding stone.
4.4.1. check that grinding stones are not damaged in any way such as cracks, deformations or splinters etc. damaged stones must not be used.
4.4.2. use wrenches provided to loosen collet locking collar. insert grinding bit and re-lock collar.
8
dO nOt
allow die grinder to free run for an extended period of time as this will shorten bearing life.
5. Maintenance
WArninG! disconnect die grinder from air supply before changing accessories, servicing or performing maintenance. replace or repair
damaged parts. use genuine parts only. unauthorised parts may be dangerous and will invalidate the warranty.
5.1. if air supply does not have an oiler, lubricate the air tool daily with a few drops of sealey air tool oil dripped into the air inlet to prolong its
life.
5.2. clean the die grinder after use.
5.3. loss of power or erratic action may be due to the following:
a) excessive drain on the air line. moisture or restriction in the air pipe. incorrect size or type of hose connectors. to remedy check the air
supply and follow instructions in section 4.
b) Grit or gum deposits in the die grinder may also reduce performance. if your model has an air strainer (located in the area of the air
inlet), remove the strainer and clean it. flush the die grinder out with gum solvent oil or an equal mixture of sAe no 10 oil and
paraffin. Allow to dry before use.
5.4. for a full service contact your local sealey service agent.
5.5. When not in use, disconnect from air supply, clean die grinder and store in a safe, dry, childproof location.
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMpOrtant:
no liability is accepted for incorrect use of this product.
Warranty:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
www.sealey.co.uk
01284 757500
01284 703534
environmental protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
parts support is available for this product. to obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.
GsA67.V2 | issue 1 16/01/17
Original Language Version
© Jack sealey limited
