4. .oPeRAtIon
4.1.
Use of tool.
4.1.1.
Before each use of tool make sure that the pneumatic system is not damaged.
damaged parts should be replaced before use.
4.1.2.
dry the pneumatic system before use.
4.2.
connection of the tool to pneumatic system.
4.2.1.
let a few drops of oil with a viscosity sAe 10 to the air inlet.
4.2.2.
Screw air connector into body of sander (fig.1).
4.2.3. connect the tool to pneumatic system using a hose of inner diameter
10 mm / 3/8 “. make sure that the hose resilience is at least
1,38 Mpa (fig.3).
4.2.4.
Adjust the air pressure.
4.2.5.
start the tool for few seconds making sure that it does not produce any
suspicious noises or vibrations.
4.3.
Assembly (fig.2.)
4.3.1.
ensure maximum speed of abrasive disc is greater than that ot the sander.
4.3.2.
Lock the spindle (fig.2). with spanner
4.3.3.
Holding the spindle, firmly tighten the wheel to spindle.
4.3.4.
Grinder is equipped with Velcro to allow installation of various overlays, such as sandpaper. sandpaper should be placed
concentrically. it is recommended to attach to disc the sanding sheet with holes cut out so that the holes in the disc match
the holes in shield. This will increase the efficiency of removal of dust created during operation.
Attention! Before attachment of the overlay you should check it for a damage,
do not
use damaged overlays.
4.4.
Connecting of the grinder to dust extraction system (fig.4.)
4.4.1.
GsA06 is equipped with a connector for connecting a hose / dust bag (supplied). the hose must be pulled onto the connector
for dust extraction. At the other end of the hose attach bag for dust collection and secure it with a hose clamp (available separately). the
stream of air, which is created during the sanding operation, will provide dust extraction. Increase of efficiency of dust extraction can be
achieved by connecting the other end of hose to the dust extraction systems, eg. industrial vacuum cleaner.
4.4.2.
GsA05 can be attached to an extraction system via a hose (not supplied).
4.4.3.
GsA04 Has no dust extraction.
8
do not
attached a bag directly to the sander the rotating wheel may catch the bag.
4.5.
operation of the sander.
4.5.1.
on the wheel attach overlay, which is appropriate for task. depress valve lever to start the sander and allow the disk to reach its full
speed, before use.
Original Language Version
© Jack sealey limited
GsA04,GsA05,GsA06 | issue 1 31/10/16
fig.4
fig.3
fig.1
fig.2
