instructions for
drum grab 350kg capacity
model no:
dg01
thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SaFEty
9
lifting crane/hoist should only be used by fully trained personnel.
8
dO NOt
use on drums with removable tops.
9
dO NOt
overload the drum grab - maximum capacity is 350kg.
9
Only use on firm, level, unobstructed surfaces which are capable of supporting the crane and the grab as well as a fully loaded drum.
9
if using a hoist do not exceed the rated capacity of the hoist.
9
Whilst operating the crane/hoist and drum grab ensure a safe distance from other personnel.
9
this product should not be used for lifting or moving empty drums.
9
When lifting the grab by hand, keep fingers and hands away from the hinged centre of the grab to avoid any scissor action.
WarNiNg!
Failure to comply with these instructions may result in loss of load, damage to crane/hoist and drum grab or other property
and/or personal injury.
9
The drum should only be transported over flat level surfaces.
8
dO NOt
use the grab if it has been damaged or has become distorted.
2. iNtrOductiON
Lifts open or closed, loaded, steel drums with the aid of an overhead hoist or mobile crane. Keeps drum in vertical position reducing
spillage. Heavy-duty steel construction. suitable for use with 205ltr drums.
NOtE:
only for use with drums having a permanently fitted top.
dO NOt
use on drums with removable tops.
3. SpEciFicatiON
model no: ......................................................................... dG01
capacity: .........................................................................350kg
drum size: ........................................................................205ltr
Weight: ................................................................................9kg
4. aSSEmbly
4.1.
Place the two halves of the grab together as shown in fig.1 so that the pivot holes are aligned and slide the pivot pin ‘A’ through both
halves of the grab.
4.2.
slide washer ‘c’ over the end of the protruding pivot pin (see fig.2) and secure the assembly by inserting the retaining clip ‘B’.
4.3.
When the assembled grab is laid down it will tend to fold flat. if the grab is then picked up by hand at the lifting point ‘f’ (see fig.3)
the grab will tend to close up. for this reason it is important to keep your hands away from the central pivot area to avoid any scissor
action that could trap your hands or fingers.
4.4.
When placing the grab onto the top of a drum lift the grab with two hands at points ‘d’ & ‘e’ (see fig.3).
refer to
instructions
Fig.1
Fig.2
Fig.3
dG01 | issue:2 (l) 24/05/17
Original Language Version
© Jack sealey limited
