WARNING! DO NOT
sand any materials containing asbestos.
8
DO NOT
carry the sander by the electrical cable.
8
DO NOT
connect to a standard vacuum cleaner to extract dust as damage to the cleaner may result.
8
DO NOT
get the sander wet or use in damp or wet locations.
8
DO NOT
use the sander with water, the sander is for dry use only.
8
DO NOT
operate the sander if you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT
use where there are flammable liquids, solids or gases such as paint solvents or waste wiping or cleaning rags.
8
DO NOT
leave the sander running unattended.
8
DO NOT
carry the sander with your finger on the power switch.
9
When not in use disconnect from the power supply and store in a safe, dry, childproof area.
2. INTRODUCTION
P
atented eccentric assembly with sealed double bearings give 9mm orbital diameter. Variable speed control from 2000-4600rpm. Fitted with
2m mains cable and 3-pin plug. Alloy bevel gear head with smooth composite motor housing for added comfort. Side mounted slider type
power control with power lock. Supplied with Ø150mm hook-and-loop pad and side handle.
3. SPECIFICATION
Model No ...........................................................
DAS150T.V6
Pad Size ................................................................. Ø150mm
Thread size .............................................................
5/16”UNF
Motor Power..................................................................
710W
Supply ............................................................................
230V
No load speed .................................................
2000-4600rpm
Orbit Size .................................................................... Ø9mm
Consumables:
Ø
145mm DA backing pads:
...................................................
5/16”UNF (soft):
.................................................
PTC/150SA
H
ook & loop 5/16”UNF (hard):
.............................
PTC/150VA
Carbon brush: ...............................................
DAS150T.V6-38
4. ASSEMBLY
WARNING!
DO NOT
plug sander into the mains power supply before it is fully assembled.
Unpack the sander and check contents. The contents should include a spanner, side handle and backing pad, should there be any
damaged or missing parts contact your supplier immediately. Screw handle (fig.1.2) into the hole (right or left side, as required) in the
head. Screw the sanding pad onto the spindle (fig.1.3). To remove pad, hold spindle with the spanner supplied whilst unscrewing the
pad.
5. OPERATION
WARNING!
Before use, ensure that you have read and understood Section 1 Safety Instructions.
5.1.
Attach the correctly rated sanding disc (not supplied) to the sanding pad.
5.2.
Plug the sander into the mains power supply.
5.3.
Ensure that the speed scroll switch is set to the lowest setting before starting the sander (fig.1.4). Grip the handle and turn on by
pushing switch (fig.1.1) forward and then pressing the front of it down until a click is heard. Let go of the switch and the machine will
continue running. Increase the speed of the sander using the variable switch located at the rear of the sander (fig.1.4).
5.4.
To release the switch, and stop the sander, press down on the rear section of the switch (fig.1.1) - it will spring to the Off position.
5.5.
Ensure that the above features are working correctly prior to use.
NOTE:
The sander is designed for dry use only.
DO NOT
use with water or any other liquids.
Original Language Version
© Jack Sealey Limited
D
AS150T.V6 Issue 1 11/08/20
fig.1
