400L/50L PORTABLE COMBI FUEL TANK
MODEL NO:
D440T
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
This tank must ONLY be used for diesel fuel and AdBlue®.
9
Place the tank on a flat surface before filling.
9
Secure the tank to strong points with ratchet straps before transporting in or on a vehicle.
9
Maintain the pump in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use recommended parts only. Non authorised parts may be dangerous and will invalidate the
warranty.
9
Keep the pump clean for best and safest performance.
9
Ensure the power supply (vehicle battery) corresponds with the requirements of the pump (12V DC).
9
Disconnect from battery when not in use.
9
Wear protective gloves, and protective clothing when working around fuel. A full range of personal safety equipment is available from
your local Sealey Stockist.
9
Keep children and unauthorised persons away from the working area.
8
DO NOT
place the tank near any heat source.
8
DO NOT
start or stop the pump by connecting or disconnecting the battery clamps.
8
DO NOT
allow the unit to get wet.
8
DO NOT
operate the pump with wet hands.
8
DO NOT
use the pump where explosive or flammable vapours may be present.
8
DO NOT
tamper with the pump connections.
2. INTRODUCTION
M
anufactured from hard-wearing and durable polyethylene. Main 400L capacity tank suitable for diesel, supplied with a 12V, 40L/min pump kit
and automatic shut-off nozzle. A removable 50L tank for AdBlue®, supplied with a 12V, 17L/min pump kit and manual nozzle. Includes 2 x 4m
delivery hoses, 2 x dispenser nozzle holders, 2 x 4m of cable and clamps to connect to a battery. Covered by a lockable lid. Not suitable for
petrol. Complies to ADR 1.1.3.1.C for exemption from requirements of ADR regulations.
3. SPECIFICATION
MODEL NO: ............................................................... D440T
Capacity:
.......................................
Diesel 400L/AdBlue® 50L
C
urrent: .....................
Diesel Pump; 15A, AdBlue Pump®; 6A
F
low Rate:
.......................
Diesel; 40L/min, AdBlue®; 17L/min
P
ower:
....................................
Diesel; 180W, AdBlue®; 120W
S
ize (W x D x H):
..................................
1150 x 800 x 860mm
Voltage:
............................................................................
12V
4. OPERATION
4.1.
TRANSPORT
4.1.1.
Move the empty tank assembly with two persons using the
hand holds moulded into the base of the unit (fig.1.1).
4.1.2.
Move with a forklift truck using the fork locations shown in
(fig.1.2). Ensure that the filler (fig.2.4) is closed before
moving.
4.1.3.
Secure the tank to the carrying vehicle by ratchet straps.
Locations for the straps are moulded into the tank. (fig.1.3).
4.2.
FILLING
8
DO NOT
run the pump without fuel in the tank. To do so will
damage the pump’s internal components and will void your
warranty.
4.2.1.
The tank is filled by unscrewing the filler (fig.2.4) in and
anticlockwise direction. Refit the filler cap immediately after filling.
WARNING!
Take care not to overfill the tank.
fig.1
D
440T Issue 1 14/06/2021
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
Wear protective
gloves
Wear safety
footwear
Wear protective
clothing
