PORTABLE DIESEL TANK 200LTR 12V
MODEL NO:
D200T
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
this tank must
ONLY
be used for diesel fuel.
9
Place the tank on a
flat surface before filling.
9
Secure the tank to strong points with ratchet straps before transporting in or on a vehicle.
9
Maintain the pump in good condition (use an authorised service agent).
9
Replace or repair damaged parts.
Use recommended parts only. Non authorised parts may be dangerous and will invalidate the warranty.
9
Keep the pump clean for best and safest performance.
9
Ensure the power supply (vehicle battery) corresponds with the requirements of the pump (12V DC).
9
Disconnect from battery when not in use.
9
Wear protective gloves, and protective clothing when working around fuel. A full range of personal safety equipment is available from your
local Sealey Stockist.
9
Keep children and unauthorised persons away from the working area.
8
DO NOT
place the tank near any heat source.
8
DO NOT
start or stop the pump by connecting or disconnecting the battery
clamps.
8
DO NOT
allow the unit to get wet.
8
DO NOT
operate the pump with wet hands.
8
DO NOT
use the pump where explosive or flammable vapours may be
present.
8
DO NOT
tamper with the pump connections.
2. INTRODUCTION
Manufactured from HDPE for the safe transportation and dispensing of diesel
fuel when supplying on site equipment. Complies to ADR 1.1.3.1.C for exemption
from requirements of ADR regulations. Supplied with a 12V electric pump, 4mtr
electric cable and clamps and a 4mtr delivery hose with automatic fuel nozzle.
Can be safely secured and transported on a pick-up truck or van, using grooves
for tie-down straps and 6 handles for positioning. Supplied with lockable cover.
Not suitable for petrol.
3. SPECIFICATION
Model No:
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
D200T
Voltage:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12V
Current:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15A
Power: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 180W
Tank Capacity: . . . . . . . . . . . . . . . . . . . . . . . . . . . 200ltr
Flow Rate: . . . . . . . . . . . . . . . . . . . . . . . . . . . .20ltr/min
Duty Cycle: . . . . . . . . . . . . . . . . . 30mins on/30mins off
Dimensions (W x D x H): . . . . . . .1100 x 800 x 470mm
Nett Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . 30.42kg
D200T | Issue 1 26/11/18
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear protective
gloves
Wear protective
clothing
Key: (fig.1. & fig.1A).
1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Breather Lid
2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Pump On/Off Switch
3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Battery Clips
4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Automatic Fluid Nozzle
5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Securing Strap Locations
6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Vent Plug
7 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Fork Locations
8 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Moulded Hand Holds
1
2
3
4
5
5
6
7
7
8
8
Wear safety
footwear
fig.1
fig.1A
