instructions for
Dual wheel separator
model no:
cv500
thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. saFetY
warNING!
ensure Health and safety, local authority and general workshop practice regulations are adhered to when using tools.
8
Do Not
use tools if damaged.
9
maintain tools in good and clean condition for best and safest performance.
9
Wear approved eye protection. A full range of personal safety equipment is available from your sealey stockist.
9
Wear protective gloves. A full range of personal safety equipment is available from your sealey stockist.
9
Wear safety footwear. A full range of personal safety equipment is available from your sealey stockist.
9
Wear ear protection. A full range of personal safety equipment is available from your sealey stockist.
9
IMportaNt:
refer to vehicle manufacturer’s service instructions or a proprietary manual to establish the current procedure and data.
2.
i
INtroDuctIoN
designed to remove stubborn steel wheels on commercial vehicles. Applicable to twin or single wheel set up. suitable for separation of
stuck or frozen dual wheel arrangements on most dual wheeled vehicles. suitable for use with air / electric impact guns. Blackened finish
for corrosion resistance. supplied in a storage case.
3.
i
coNteNts
4. asseMblY
Apply thread lubricant to forcing screw thread. there are two Pullers supplied. ensure the correct size is used for the wheels being
serviced.
cV500 issue 1 27/02/18
Original Language Version
© Jack sealey limited
refer to
instruction
manual
Wear eye
protection
Wear protective
gloves
Wear safety
footwear
Wear ear
protection
fig.1
Item
Description
part Number
1
Holding Piece
cV500.01
2
separator (large)
cV500.02
3
separator (small)
cV500.03
4
force screw
cV500.04
