Original Language Version
© Jack sealey limited
2. introduction
l
ightweight, compact and ergonomically designed. Features heavy-duty alloy bevel gear head with aluminium gear casing. Features spindle lock
for quick disc changes and adjustable disc guard. Supplied with side handle and soft grip for added comfort and control. Powered by Lithium-ion
battery, which maintains a high energy density level with a flat discharge curve - performing better and longer than a conventional Ni-Cd/Ni-MH
battery. supplied with 1 hour mains charger and battery in storage case.
3. sPecification
model no: ...............................................................cP20VAG
B
attery: ...........................................................
20V 3Ah Li-ion
disc size: .................................................................Ø115mm
spindle size: ....................................................... m14 x 2mm
motor Power: .................................................................
700W
no load speed: .................................................... 10,000rpm
r
eplacement Battery:
.............................................
CP20VBP
W
eight: ........................................................................
2.36kg
noise Power: ..........................................................
96.06dB.A
noise Pressure: .....................................................
85.06dB.A
Vibration: ...............................................................
6.151m/s
2
Vibration uncertainty: .................................................
1.5m/s
2
4. Battery charging
note-:
When new, the batteries will have been shipped in a low charge state. Fully charge the batteries before using your tool.
4.1.
to remove the battery from the grinder, depress the spring loaded button on the battery pack. remove the battery pack by sliding out.
do not
touch the metal battery terminals.
4.2.
The battery is designed to fit into the charger one way only. Insert the battery fully and firmly to seat the battery into the charging base.
4.3.
take the base charger and plug it into the mains, switch on the power the red led on the charger will illuminate.
4.4.
When the battery is on charger the green LEDs on the battery will illuminate and pulse on/off, this indicates the battery is now
charging.
4.5.
When the green LEDs illuminate permanently the battery is fully charged. The red LED will extinguish.
4.6.
during the charging process the battery status can be checked by pressing the button on the battery. no lights indicates battery is
“flat”, three lights on indicates battery fully charged.
4.7.
remove the battery from the charger. switch off and remove the plug from the mains. Push the battery back into the grinder until it
snaps into place. the grinder is now ready for use.
5. Wheel / disc fitting
note-:
remove battery to avoid accidental starting.
5.1.
clamp the wheel guard to the neck of the grinder. the orientation can be changed to suit the task later.
5.2.
fit the side auxiliary handle to the user preferred side.
5.3.
fit the inner clamp ring, registering slot flats with the spindle flats.
5.4.
Offer a grinding wheel/cutting disc (115mm diameter with *22mm diameter bore and boss minimum thickness 3mm) on to the inner
clamp ring spigot. If the boss thickness is less than 3mm, reverse the clamp ring fitting, such that the spigot is outboard.
5.5.
Wind on the outer clamp ring with the 22mm diameter spigot inboard entering the grinding wheel bore.
5.6.
With the pinned wrench, clamp the grinding wheel/cutting disc. Resistance to the gearbox turning in this process is offered by
pressing the button on the casing head. turn the wheel and press the button until the locking position is found.
5.7.
read the instructions for operation of the grinder and then fit the charged battery.
(*14mm bore grinding wheel/cutting discs (not recommended) must be clamped spigot to spigot.)
c
P20VAG Issue 2 (1, F) 28/12/17
