EnVIRonMEnTAL PRoTECTIon
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycle centre and disposed of in a manner which is compatible with the environment.
When the product is no longer required, it must be disposed of in an environmentally protective way.
BATTERY REMoVAL
1. Remove the battery pack - see section 3.1.1.
2. Dispose of spent battery pack correctly.
ONLY
dispose of or recycle according to local authority regulations.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential
purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s
registered compliance scheme.
Jack Sealey Ltd’s Batteries Producer Registration number (BPRn) is BPRn00705
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMpORTANT:
no liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole Uk Distributor, Sealey Group,
Kempson Way, Suffolk Business
Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
Ni-Cd
Original Language Version
CP14035V Issue:4 - 12/01/12
3.2.2. Insert the required drill or screwdriver bit fully into the chuck
and tighten chuck.
3.2.3. The speed of the drill is controlled by the variable power
trigger.
After moving the direction switch to ‘forward’ or ‘reverse’ as
appropriate, squeeze the power trigger gently for a slow
speed and progressively increase the pressure on the trigger
to produce correspondingly higher speeds.
3.2.4.
To select torque or drill setting, twist the torque selector ring
to the required setting - from 1 (the lowest) to 21 (the highest)
for torque setting or to the drill symbol for drilling. (See fig.2).
3.2.5.
Drilling.
Insert a pilot drill bit (a smaller sized drill than the required
finished hole size) into the chuck and lock in position. Check
to confirm the rotational direction is correct (
DO NOT attempt
to change direction whilst the drill is running).
After drilling the inital pilot hole, insert the final sized drill bit
and drill out the hole to the appropriate size. If the drill
becomes stuck, release the trigger and place the drill in
reverse and try running the drill slowly whilst moving the drill
out of the hole. If this does not work, gently work the drill bit
free. If the chuck stops turning, check the torque setting.
3.2.6.
To check the condition of the battery, press and hold the
battery indicator button next to the battery level indicator at
the rear of the drill.
3.2.7. When finished working, remove the bit from the chuck, clean
drill and bit, and store in the case.
fig.2
